Network (M18); Reset Settings (M19) - NEC 411I Manual

No. Security
1 Change PINs Changes the PIN or PIN2 code (PIN activate setting must be turned on to change the PIN code).
2 PIN activate Turns on/off the PIN code entry required at starting up the phone.
3 Change Changes the security code which is used to set some of functions and unlock the Personal Information Manager (PIM)
security code features.
The default setting of the security code is "0000".
4 Phone lock Turns on/off the Phone lock function which will lock the phone: you can only make emergency calls or enter the security code.
After entering the correct security code, you can use the phone normally.
Upon power-up, you are prompted to enter the security code if the Phone lock was active when the phone was powered
down.
5 Bar calls You can bar the following calls made/received on your phone: all outgoing (dialled) calls, international outgoing (dialled) calls,
international outgoing (dialled) calls except to home, all incoming (received) calls or Incoming (received) calls when roaming.
Bar calls facilities are network services and may require a password.
1
2
6 Fixed dialling Turns on/off the fixed dialling which restricts the use of dialled number to only the Fixed Dialling Numbers (FDN).
The FDN facility is network dependent.
See also: "Fixed dialling numbers (FDN)" on page 51.

Network (M18)

☛
1 8
For settings provided on the Network screen, see "Roaming" on page 15.

Reset settings (M19)

☛
1 9
This function will reset your phone to its factory settings.
By restoring the factory settings, any changes you have made to your phone EXCEPT the following will return to the factory settings (the
following data/settings will not be reset):
☛
Change settings Highlight the type of restriction and the call type, and then
☛
Key in your bar calls password to verify user identification to the network
and save changes to the network.
The selected settings have red bars over their icons.
Set password Changes the bar calls password.
➔
to save changes.
➔ SK1 to confirm
27
Settings (M1)