Page 1
ELECTRIC PLATE COMPACTOR Operations Manual MODEL NUMBER: eJXPC20 To reduce the risk of injury, the user must read and understand the Operator’s Manual before using this product. Save these instructions for future reference.
Table of Contents 1. SAFETY INFORMATION 1.1 Fire Safety 1.2 Operating Safety 1.3 Service Safety 1.4 Electric Motors 1.5 Plugs 1.6 Extension Cables 1.7 NVR - No Volt Release 1.8 Health and Safety 2. TECHNICAL DATA 2.1 Product Features 2.2 Product Dimensions 2.3 Compactor Specifications 2.4 Product Parts 3.
Page 3
Register Your Equipment Thank you for purchasing TOMAHAWK equipment! Your product is covered by the TOMAHAWK Warranty policy, but in order to activate your warranty, we need you to register your product. In addition to activating your equipment warranty, product registration will grant you access to important product updates, streamlined customer service and more.
Tomahawk Power. The information contained in this manual is based on machines in production at the time of publication. Tomahawk Power reserves the right to change any portion of this information without notice.
1.2.2 NEVER use accessories or attachments for this equipment, which are not recommended by TOMAHAWK POWER. Damage to the rammer and/or injury to user may occur.
WARNING this equipment safely. If you are unsure about the safe and correct use of the eJXPC20 Plate Compactor, consult your supervisor. 1.3.1 DO NOT attempt to clean or service machine while it is running. Rotating parts can cause severe injury.
1.5 Plugs The eJXPC20 Plate Compactor is intended for DIY or site usage, the following plug types are supplied/fitted to the product: 15 amp rated 120 volt plug type. THIS PRODUCT MUST BE GROUNDED...
2.1 Product Features The future of compaction is here: introducing the Tomahawk Electric Plate Compactor. Extreme power, zero emissions. The new eJXPC20 Electric Plate Compactor combines the old with the new: the same unstoppable force as our gas-powered compactors, without engine emissions for use outdoors and indoors.
2.3 Compactor Specifications eJXPC20 Model Motor 120V~60Hz Power 130W Motor Speed (rpm) 3450 14.2 Input Power Current Compaction Force 16x13 in.( 40x32 cm) Base Plate Dimensions(LxW) 32 ft (10 m) Cable Length 94 dB(A) Noise 62 lbs (28kg) Product Weight 2.4 Product Parts...
The following pre start-up inspection must be performed before the start of each work session or a er every four hours of use, whichever is first. Please refer to the service section for detailed guidance. If any fault is discovered, the eJXPC20 plate compactor must not be used until the fault is rectified.
If necessary, use a suitable rope attached to the eJXPC20 at a low point on the chassis, to allow a helper to take part of the eJXPC20's weight. Work up and down a slope not across.
5.1 Maintenance The Electric Plate Compactor is designed to give many years of trouble free operation. It is recommended that an approved TOMAHAWK POWER dealer or service center carries out all major maintenance and repairs. Always use genuine TOMAHAWK POWER replacement parts, the use of spurious parts may void your warranty.
For your convenience we have provided this space to record relevant data about your plate compactor. 5.5 Replacement Parts For replacement parts and technical questions visit www.tomahawk-power.com or scan the QR code on the front of this manual. • Not all equipment components are available for replacement. The illustrations within this manual are a convenient reference to the location and position of parts in the assembly sequence.
Contact Tomahawk Power. down Verify the load has not changed. Verify equipment Load increased hasn't got tighter. If fan application verify the air low hasn't changed or Contact Tomahawk Power Defective capacitor Contact Tomahawk Power Faulty stationary switch Contact Tomahawk Power...
7. EQUIPMENT WARRANTY Your new TOMAHAWK® equipment is warranted to the original purchaser for a period of one-year (12 months) from the original date of purchase. The TOMAHAWK® warranty is against defects in design, materials and workmanship. The following are not covered under the warranty: 7.1.1 Damage caused by abuse, misuse, dropping or other similar damage caused by or as a...
9. MORE COMPACTION TIPS 9.1 Soil Drop Test: Soil preparedness refers to the “wetness” of the dirt or soil. Soil needs to be 50% dry and 50% wet, before starting compaction. A simple “hand test” can deter- mine this. Pick up a handful of soil with your hand and squeeze the dirt. Observe whether the soil is powdery or if it breaks apart when dropped.
Page 17
9.3 Compaction Terms 9.3.1 Cohesive soils: Clays and mixes have a particular particle size of less than .003” or .002” and are typically classified as cohesive soils. This type of soil is primarily used for retaining pond beds and mound fills. These soils are dense due to the strongly bound mo- lecular attraction.
Page 18
9.4.4 Static Force: Found in the deadweight of machines, static force applies pressure downward on soil surfaces. As a result, soil particles compress in the topsoil layer. 9.4.5 Vibratory Force: This force is engine-driven, creating a downward force, in addition to the machine's static weight.
Page 19
POWER YOUR WORLD Powered by a superior 7Ah lithium battery with up to 11 hours of life adjustable pressure from 20 to 70 PSI, Tomahawk Battery Sprayers are Item #: eTPS18 4.75 GALLON BATTERY BACKPACK SPRAYER www.tomahawk-power.com...
Page 21
Lose the manual pump and gain the power to spray 15,000 ft² in 10 minutes or less while maintaining constant, adjustable pressure from 50-435 PSI with your ideal concrete sealant, cure, top cast, form release, and more! Item #: TCS6.5 6.5 GAL MOTORIZED CONCRETE SPRAYER www.tomahawk-power.com...
ELECTRIC PLATE COMPACTOR Parts Manual MODEL NUMBER: eJXPC20 To reduce the risk of injury, the user must read and understand the Operator’s Manual before using this product. Save these instructions for future reference.
Page 25
Parts List Item NO. Description Part No. Item NO. Description Part No. On-off switch assembly 3141804003 On-off switch assembly 3141804003 Cover fixing bar Front 3021804003 Inner socket bolt 4010400005 Cover fixing bar Side 3021804005 Lock nut 4020200003 Cover fixing bar Rear...
Page 26
30" Diameter, 4-Blade Assembly 10 ft Full Hydrostatic, 74 HP Hatz TRT60V TPT46H Adjustable Blade Pitch from 0-28 4 ft, Honda GX270/GX390, 0-28 Blade Pitch Diesel HAVE QUESTIONS? Contact us. We’re here to help! (866) 577-4476 Email us at sales@tomahawk-power.com...
Page 27
Tilt, 8 Hour Run Time 4" Pump, Honda GX390, 581 GPM, 210 Amp Welder, 60% Duty Cycle, TW4H TWG210A Elevation: 92ft, Suction: 26ft Snow Plow Attachment & Bucket Extender Available 2000w, Includes Wheel Ki ASSEMBLED IN THE (866) 577-4476 www.tomahawk-power.com PARTS SOURCED GLOBALLY...
Page 28
With same day shipping and faster delivery times, count on Tomahawk to keep you powered throughout the day! With long lasting parts and engines, Tomahawk equipment will be the star of your fleet for years to come. Visit www.tomahawk-power.com to get started today!
Need help?
Do you have a question about the eJXPC20 and is the answer not in the manual?
Questions and answers