Ipsec Settings Guide (For Reference/Example Only); Tunnel Between Two Smcbr14Vpn; Settings For Router 1 - SMC Networks BR14VPN - annexe 3 Manual

8 | IPSec Settings Guide (For Reference/Example Only)

8.1 | Tunnel between two SMCBR14VPN

The easiest way to construct a VPN tunnel between two sites is to use two SMCBR14VPNs, which
are connected to the internet.
The steps to follow to create an IP tunnel between are the following:
Step 1: Go to the VPN section and select the enable checkbox for [VPN]
•
Step 2: Select the number of Tunnels you want to enable
•
Step 3: Enter a Tunnel Name, select IKE or MANUAL for the method and click [More]
•
Step 4: Local subnet value is the LAN SUBNET
•
Step 5: Local netmask value is the LAN SUBNET MASK
•
Step 6: Remote subnet value is the LAN SUBNET of the REMOTE NETWORK
•
Step 7: Remote netmask value is the LAN SUBNET MASK of the REMOTE NETWORK
•
Step 8: Remote gateway value is the WAN IP of the REMOTE NETWORK
•
Step 9: Preshare key value is used to determine the network encryption
•
Step 10: SAVE SETTINGS and then configure the IKE PROPOSAL and IPSEC PROPOSAL
•

8.1.1 | Settings for Router 1

VPN Router 1 WAN IP Address: ip1.smc.com
LAN IP Address: 192.168.1.1
PC 192.168.1.xxx
47