A.R.C. Laser FOX ENDO Quick Manual

FOX ENDO - QUICK-GUIDE
1) Sockets
Rear side of the Fox
CIRCLE Power- Door AUX 1
CIRCLE CIRCLE
supply Interlock AUX 2
CIRCLE
CIRCLE Power supply &
Door-Interlock inserted
CIRCLE
1) For a reliable operation keep the
inserted. in case the laser has to be operated by bat-
tery, please check the proper battery level and insert the
foot switch.
CIRCLE
3) Enter password
3) Enter Password: Please use the pass-
word you received from our local dis-
tributor.
Enter the correct 4-digits code to switch
to the laser screen.
WARNING!
Keep in mind that the used laser might
cause serious harm!
WEAR GOGGLES, when using the laser!
CAUTION LASER DIODE: Never open the housing! Keep the device from untrained persons. There are no serviceable parts inside
the device. Maintenance and service operations can only be performed by authorized persons or A.R.C.-trained dealers.
2) Switch on
Please check before switching on
Foot switch
CIRCLE
Fiber-Port
CIRCLE
2) Prior switching on the fiber port has to be empty.
An inserted fiber will interrupt the startup and a warning
Door-Interlock
CIRCLE
message will be displayed.
User Manual FOX 514
Please check the emergency button
September 2021
not pushed down or got stuck.
6.3 Programs and Settings
4) Main Screen
6.3.1 Display / Main Menu
Battery mode
Settings
Power
Pulse length
Decrease or increase of
Aiming beam brightness
chosen values using the
Decrease or increase of brightness
arrows on the left
when fiber is inserted using the
circular plus and minus buttons
6.3.2 Saving parameters
How the parameters for power / pulse length / pulse interval can be changed is described in
the following three sections.
To store the modified parameters, please press the plus and minus buttons for adjusting the
aiming beam brightness for a few seconds. The saved parameters are stored as basic setting
when the device is switched on again.
6.3.3 Power settings
The power can be set by using the rotary wheel. Doing so,
CIRCLE CIRCLE
CIRCLE CIRCLE
CIRCLE CIRCLE
Warning label Emergency-Off
CIRCLE CIRCLE
CIRCLE
to be open and
CIRCLE
Reset Button
Pulse counter
5) The
can be set by
using the rotary
wheel. Doing so,
the color of the
value is changed.
Pulse pause
Modify values using the
arrows on the right
Identify the buttons to switch on the laser
CIRCLE CIRCLE CIRCLE CIRCLE
Press both buttons to switch
on the laser
Push and hold (2s) the both buttons to turn on the FOX.
the red diode indicators light up and the Start-LED be-
gins to blink. The laser starts. It will take some seconds
cause the laser will check several security circuits.
6) Insert Fiber
power
6) The applicator can be plugged into the
laser device. If perfectly inserted, you
should hear a "click".
Press the READY button, to switch to
READY mode. and the aiming beam will
be visible. Without a fiber it will not be
possible to switch on the READY mode.