Snmp-Server Trap - SMC Networks 2555W-AG2 User Manual

Command Usage
The snmp-server host command is used in conjunction with the
snmp-server enable server command to enable SNMP notifications.
Example
Enterprise AP(config)#snmp-server host 1 10.1.19.23 batman
Enterprise AP(config)#
Related Commands
snmp-server enable server (7-41)

snmp-server trap

This command enables the access point to send specific SNMP traps
(i.e., notifications). Use the no form to disable specific trap messages.
Syntax
snmp-server trap <trap>
no snmp-server trap <trap>
• trap - One of the following SNMP trap messages:
- dot11InterfaceAGFail - The 802.11a or 802.11g interface has failed.
- dot11InterfaceBFail - The 802.11b interface has failed.
- dot11StationAssociation - A client station has successfully associated
with the access point.
- dot11StationAuthentication - A client station has been successfully
authenticated.
- dot11StationReAssociation - A client station has successfully
re-associated with the access point.
- dot11StationRequestFail - A client station has failed association,
re-association, or authentication.
- dot1xAuthFail - A 802.1X client station has failed RADIUS
authentication.
- dot1xAuthNotInitiated - A client station did not initiate 802.1X
authentication.
- dot1xAuthSuccess - A 802.1X client station has been successfully
authenticated by the RADIUS server.
- dot1xMacAddrAuthFail - A client station has failed MAC address
authentication with the RADIUS server.
- dot1xMacAddrAuthSuccess - A client station has successfully
authenticated its MAC address with the RADIUS server.
- iappContextDataSent - A client station's Context Data has been sent to
another access point with which the station has associated.
- iappStationRoamedFrom - A client station has roamed from another
access point (identified by its IP address).
7
SNMP Commands
7-43