Martha Stewart PHILIPPE LOVESEAT WITH LUMBER PILLOW Assembly Instructions Manual

Advertisement

ASSEMBLY INSTRUCTIONS
PHILIPPE LOVESEAT WITH LUMBER PILLOW
Please read below before assembly
Assemble the product on a flat, soft surface such as a carpet or cloth to prevent scratching
the finish.
Do not discard any content until assembly is complete to avoid accidentally discarding small
parts or hardware.
Take out all parts and hardware from box.
Failure to follow these instructions may cause the bolts to misalign during assembly.
DISCLAIMERS:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE
FOR ANY DAMAGES RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE. THEY SHOULD BE INSPECTED AT LEAST
EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO PREVENT DAMAGE OR INJURY, AND
ENSURE STABILITY.
PEOPLE NEEDED
PHILLIPS HEAD SCREW DRIVER
TOOLS REQUIRED (NOT INCLUDED)
600
Lbs seat
WEIGHT LIMIT
10
Minutes
ESTIMATED TIME
RUBBER MALLET
Page 1 of 7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PHILIPPE LOVESEAT WITH LUMBER PILLOW and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Martha Stewart PHILIPPE LOVESEAT WITH LUMBER PILLOW

  • Page 1 ASSEMBLY INSTRUCTIONS PHILIPPE LOVESEAT WITH LUMBER PILLOW Please read below before assembly Assemble the product on a flat, soft surface such as a carpet or cloth to prevent scratching the finish. Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
  • Page 2: Parts List

    PARTS LIST LEFT SIDE PANEL 1 PC RIGHT SIDE PANEL 1 PC BACK 1 PC SEAT 1 PC PILLOW 1 PC Page 2 of 7...
  • Page 3: Hardware List

    HARDWARE LIST SHORT BOLT Ø1/4’’ x 1-5/8" 12 PCS LONG BOLT Ø1/4’’ x 2-3/8" 6 PCS LOCK WASHER Ø1/4’’ 12 PCS FLAT WASHER Ø1/4" 12 PCS WOOD PLUG 6 PCS ALLEN KEY Ø1/4" 1 PC STEP 1 LOCATE PARTS AND HARDWARE PER BELOW DRAWING H ARDWARE Page 3 of 7...
  • Page 4 STEP 2 3 PCS 1 PC NOTE: DO NOT FULLY TIGHTEN BOLTS STEP 3 3 PCS 1 PC NOTE: DO NOT FULLY TIGHTEN BOLTS Page 4 of 7...
  • Page 5 STEP 4 4 PCS 4 PCS 4 PCS 1 PC * FLIP SEAT BOTTOM COVER STEP 5 8 PCS 8 PCS 8 PCS 1 PC NOTE: PLEASE TIGHTEN ALL BOLTS Page 5 of 7...
  • Page 6 STEP 5 TAP GENTLY 6 PCS STEP 6 ADJUST LEVELERS FOR UNEVEN FLOOR Page 6 of 7...
  • Page 7 Care & Maintenance Do... Wipe up spills immediately. Dust and pick-up spills using a clean, non-colored, lint-free, dry cloth. Use mild non-abrasive soap and water. Don't... Do not put hot items directly on furniture surface. Do not clean furniture with harsh cleansers or polish. Do not place furniture in direct sunlight.

Table of Contents