Download Print this page

Advertisement

Quick Links

Instruction Manual
Bookcase
SKU: ZG-053-GY-MS
SKU: ZG-053-WH-GLD-MS
SKU: ZG-053-GY-BK-MS
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death or
damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult
supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Customer Service Email: CustomerExperience@theubiquegroup.com | Phone: 866-552-2810

Advertisement

loading
Need help?

Need help?

Do you have a question about the ZG-053-GY-MS and is the answer not in the manual?

Questions and answers

Summary of Contents for Martha Stewart ZG-053-GY-MS

  • Page 1 Instruction Manual Bookcase SKU: ZG-053-GY-MS SKU: ZG-053-WH-GLD-MS SKU: ZG-053-GY-BK-MS ASSEMBLY INSTRUCTIONS Before You Begin: Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
  • Page 2 • • • • • • • • • • • • • • WARNING In order to help prevent overturning please follow these instructions To help prevent product toppling over please follow the below steps: Use the anti tip strap or wall fixing method provided (if applicable) Do not allow children to climb or hang on the furniture Do not place heavy items on top of the furniture, unless the...
  • Page 3 Hardware Please check you have all the panels listed below Note: The quantities below are the correct amount to complete the assembly. In some cases more hardware may be supplied than is required. Male Camlock x 6 Female Camlock x 6 Dowel x 6 6*20mm Screw x 12 Hex Key M4 x 1...
  • Page 4 Using Camlocks Step 1 Step 2 DO NOT OVER TIGHTEN. Connect the male camlock Push the male camlock as diected in the assembly into the entry hole. instructions using a scewdriver . Step 4 Step 3 Insert the female camlock Turn the female camlock as shown in the clockwise with a...
  • Page 5 Parts...
  • Page 6 Assembly Instructions Step 1 Step 2...
  • Page 7 Step 3 Step 4...
  • Page 8 Step 5 Step 6...
  • Page 9 Step 7 Step 8...
  • Page 10 Step 9 Step 10...
  • Page 11 Step 11 Adjust Part 3 as needed. Step 12...
  • Page 12 Step 13 Step 14...
  • Page 13 Step 15 Step 16...
  • Page 14 Step 17 Step 18...
  • Page 15 Step 19 The unit is floor standing, but it is recommended that the unit is secured to the wall. 1. Move the unit into desired position. 2. Mark the wall with a suitable scribe the position of the fixing holes. Warning: Before driling,check wall for hidden pipes...
  • Page 16: Important Note

    A Guide to Wall Mounting & Hardware Important note: Important: when drilling into walls always check that there are no hidden wires or pipes etc. plastic wall anchors Make sure that the screws and wall anchors being used are suitable are supplied with your...
  • Page 17 Quality and Safety Guidelines: • Please follow the static and dynamic weight capacity limits provided on this item. If you are unsure of the weight capacities for this product, email us at CustomerExperience@theubiquegroup.com or call 866-552-2810. • Please use this item on a stable, level surface only. All table legs should contact the flooring surface when in use.

This manual is also suitable for:

Zg-053-wh-gld-msZg-053-gy-bk-ms