Download Print this page

Poly Rove 20 Pairing Manual

Pairing with the b1 base station

Hide thumbs Also See for Rove 20:

Download this manual

Pairing Rove 20 Handsets with

the Rove B1 Base Station

Need help?

Do you have a question about the Rove 20 and is the answer not in the manual?

Page 1 Pairing Rove 20 Handsets with the Rove B1 Base Station...
Page 2: Unsupported Configuration
Pairing Rove 20 Handsets with the Rove B1 Base Station This guide describes how to register and pair your Poly Rove R20 handsets with the Rove B1 base station. Suported Configuration The Poly B1 base station supports up to 10 Rove R20 handsets.
Page 3 Pairing Rove 20 Handsets with the Rove B1 Base Station NOTE: the Easy Registration process on handsets must be initiated when the base station LED is flashing green, which means the base station is in pairing mode. 5. Repeat Step 4 on all Rove handsets.
Page 4: Additional Information
IP address and signal strength, before the handsets are registered to a base station. The signal strength will vary depending if the Poly rove DECT IP phone is set up outside or the materials in a building. Here is a general reference of possible signal strengths:...
Page 5 Pairing Rove 20 Handsets with the Rove B1 Base Station Procedure 1. Place a few Poly Rove base stations and wireless handsets in the areas where you plan to set them. 2. Power on the devices and connect the LAN cable to the base stations.
Page 6 Pairing Rove 20 Handsets with the Rove B1 Base Station...