Troubleshooting - VDO MS 3000 User Manual

Hide thumbs Also See for MS 3000:
Table of Contents

Advertisement

TROUBLESHOOTING

There may be times when you suspect that your navigation system is not
functioning as you expect it to. Before calling for service please read the operating
instructions and check the following list. You may find that an apparent
malfunction can easily be rectified.
Symptoms
System dos not start. Nothing on the
display.
After some time of normal operation,
the system switches off.
System reacts very slowly to data
entries or calculates very slowly.
"Guidance" option can not be selected
from the main control menu.
System plans no route although a
destination was entered.
Only "Stand-by" can be selected in the
main control menu after switching on
the ignition.
Number of received satellites in info
screen "i3 GPS Position" is zero.
Guidance advice not audible.
Display shows "Please insert CD" or
"Please insert correct CD"
Map CD is ejected unintentionally
without pressing the W key.
Not possible to store address in the
address book.
Entered relocation junction is not
accepted during car position input.
Guidance is not precise.
Displayed car position does not match
actual car position.
40
Possible cause / Remedy
Switch on the ignition.
Ignition is already switched on:
System is in stand-by mode.
Push one of the keys on the remote control.
Monitor connector is not locked correctly.
Slide the monitor onto the support (connector) until it clicks into
position correctly.
At extreme high or low temperatures the built-in protection circuit
switches off the system automatically.
Operation of the system is resumed as soon as the temperature
returns to a normal level.
You are in a very densely digitized area. The navigation system has to
read a large amount of data from the CD-ROM.
Make sure that you entered a destination address.
Car is not on a digitized road.
Drive in the direction of the displayed arrow to a digitized road.
Wait a few seconds until the system has initialized (options appear in
highlighted letters).
Make sure the GPS aerial is not covered by any objects.
Drive outdoors, if you are in a garage, a car park or a tunnel.
Make sure that the volume is not set to minimum.
Make sure that an appropriate CD is inserted with the printed side
facing up in the navigation computer.
The CD might be dirty.
Try to clean the CD with a special CD cleaning fluid.
Address book is full.
Delete one or more entries no longer required.
Not all junctions you can enter with the "typewriter" are suitable for
relocation.
Select a junction with the list option.
Inaccuracy of a max. of 30 m is possible.
If you frequently discover greater inaccuracy, contact an authorized
service centre.
Bad GPS reception for a longer period of time (for example caused by
interference). When sufficient GPS reception is resumed the position is
corrected automatically.
If necessary wait a few minutes.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents