Download Print this page
Altec Lansing A7 Owner's Manual

Altec Lansing A7 Owner's Manual

Limited edition
Hide thumbs Also See for A7:

Advertisement

A7
Limited Edition
S/N:
MADE IN USA
O W N E R ' S
M A N U A L

Advertisement

loading

Summary of Contents for Altec Lansing A7

  • Page 1 Limited Edition S/N: MADE IN USA O W N E R ' S M A N U A L...
  • Page 2: Table Of Contents

    30-DAY PRODUCT RETURN WARRANTY If for any reason you decide that this A7 loudspeaker is not what you were expecting (including cabinet cosmetics), you may return it to us using the original packaging material within 30 days of receipt.
  • Page 3: I N T R O D U C T I O N

    The experience that is the Voice of the Theatre - a legend in its own time. (1975 Altec Lansing Product Catalog) The legacy of the A7 is a famous one. Starting life purely as a cinema playback unit, it was soon in demand for use as a studio monitor and home reproducer.
  • Page 4: U N P A C K I N G

    IMPORTANT: USE CAUTION WHEN MOVING THE LOUDSPEAKER Because each A7 weighs approximately 200 pounds, use caution when moving the loudspeaker to avoid personal injury. Use multiple people or a dolly and protective blankets when moving the loudspeaker off of the pallet and to its final location.
  • Page 5: C O M P O N E N T S

    BINDING POSTS - CARDAS ACBP-S Two pair. Non-magnetic, billet Brass, short binding post, Rhodium over Silver plate. Billet brass nut, Gold plate. Glass filled nylon insulator. We ship the A7 jumpered for mono wiring. Simply remove the jumpers for bi-amplification.
  • Page 6: A S S E M B L Y

    IMPORTANT: CHECK YOUR AMPLIFIER'S IMPEDANCE AND POWER SPECIFICATIONS This A7 loudspeaker has an 8 Ohm (_) input impedance and is designed to handle continuous input power levels of up to 125 Watts RMS. Do not connect this loudspeaker to amplifier speaker terminals which are rated at less than 8 Ohms (_);...
  • Page 7 a s s e m b l y ( c o n t . ) IMPORTANT: WIRE SIZE Ordinary commercial 18-guage, stranded, insulated wire may be used for connection of ALTEC loudspeakers. This is considered minimum size wire for speaker/amplifier connections up to 30 feet. For wire runs longer than 30 feet, 16-guage or larger wire is recommended.
  • Page 8: S P E C I F I C A T I O N S

    s p e c i f i c a t i o n s FREQUENCY RESPONSE ±10 dB 45 Hz to 20 kHz LOW FREQUENCY ROLL-OFF -3 dB 54 Hz SYSTEM POWER CAPACITY 125 W Rating based on test signal of continuous pink noise, per IEC spectrum for two hours duration.