Altec Lansing A7 Owner's Manual page 7

a s s e m b l y
( c o n t . )
IMPORTANT: WIRE SIZE
Ordinary commercial 18-guage, stranded, insulated wire may be used for
connection of ALTEC loudspeakers. This is considered minimum size wire for
speaker/amplifier connections up to 30 feet. For wire runs longer than 30 feet,
16-guage or larger wire is recommended.
Strip 0.5" of insulation off of both ends of the speaker wire if it has
STEP 1:
not already been done.
Insert the bare end of the marked wire (usually marked with a
STEP 2:
colored pattern on its insulation) into the hole in the positive (+)
speaker terminal post. Tighten the nut down securely.
Insert the bare end of the second wire into the hole in the negative
STEP 3:
(-) speaker terminal post. Tighten the nut down securely.
Lay out the wire over to the amplifier.
STEP 4:
Connect the other end of the marked wire (refer to step 2) to the
STEP 5:
positive (+) 8Ω terminal on the amplifier.
Connect the second wire to the negative (-) 8Ω terminal on the
STEP 6:
amplifier.
Power up the amplifier and enjoy the great ALTEC sound.
STEP 7:
A 7 O w n e r ' s M a n u a l 5