HOMCOM 820-083 Assembly And Instruction Manual page 3

● CAUTION — Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
● Regarding the instructions for replacing bulb, thanks to refer to the below paragraph of
the manual.
● Do not use this heater if it has been dropped.
● Do not use if there are visible signs of damage to the heater.
● Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
● WARNING: Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
● WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 1 m from the air outlet.
Operating Instructions
Never cover the heater or obstruct the opening at the base of the heater, this could
cause overheating and consequent risk of fire.
Never move the heater when it is operating, this could cause the bulb breakdown.
Please turn the heater off if you want to move it.
When you turn the heater on for the first time you may notice a slight odor, this is harmless
and will stop after a short amount of time.
Heater Control Panel
820-083:
Insert Plug Into Socket
The following switches are located under the controls cover at the front of the heater.
● Switch ( 3a ) Switchs ON/OFF electricity supply to the heater and flame effect.
Note: This switch must be in the ON position for heating operation.
● Switch ( 3b) Switchs ON/OFF 900W heat output
● Switch ( 3c ) Switchs ON/OFF 1800W output with switch 3b
Note: The flame effect can be operated with or without heat.
● Rotate thermostat control (1) clockwise or anti-clockwise to achieve desired room
temperature.
820-084/820-085:
The control switch is located on the front of the heater as below.
3