Table of Contents
Advertisement
Quick Links
WINE CABINET INSTRUCTION MANUAL
Model:
One section models:
DAB-26.60B.TO, SS.TO, W.TO
Two section models:
DAB-25.62DB.TO, DSS.TO, DW.TO
DAU-45.125DB.TO, DSS.TO, DW.TO
DX-53.130DBK/DP, SDSK/DP, DWK/DP
DAB-89.215DB, DSS, DW
Three section models:
NEW! PUSH-AND-OPEN DOOR FUNCTION (.TO)
DOOR OPENING MECHANISM
The push-and-open door function is activated when the unit is powered. To open the door, push the door slightly inwards on the
top center position and release again. The door will be opened approx. 5~7cm by the push rod. Then the door can be fully open
manually.
NOTE:
Do not block the door or hold on it while it is opening. If the door is blocked or held during opening, the door opening mechanism
and the door will be damaged. The loud and repeated cracking noises will be heard.
Do not push the push rod in or hold on to it during closing. If the push rod is blocked during closing, it will no longer be able to
reach its initial position. In the initial position, the push rod is flush with the front of control panel. In order to set the push rod
back in its initial position, disconnect the appliance from the mains, wait for approx. 10 seconds and plug it back in again. The
push rod will return to its initial position.
2018.V.1.
DX-7.20BK/DP, SSK/DP, WK/DP
DAB-28.65B, SS, W
DAU-17.57DB, DSS, DW
DAB-36.80DB, DSS, DW
DAB-49.116DB.TO, DSS.TO, DW.TO
DX-57.146DBK, DSK, DWK
DAB-114.288DB.TO, DSS.TO, DW.TO
DAB-65.178TB.TO, TSS.TO, TW.TO
Advertisement
Table of Contents
Related Manuals for Dunavox DAB-26.60B.TO
Summary of Contents for Dunavox DAB-26.60B.TO
- Page 1 WINE CABINET INSTRUCTION MANUAL 2018.V.1. Model: One section models: DX-7.20BK/DP, SSK/DP, WK/DP DAB-26.60B.TO, SS.TO, W.TO DAB-28.65B, SS, W Two section models: DAU-17.57DB, DSS, DW DAB-25.62DB.TO, DSS.TO, DW.TO DAB-36.80DB, DSS, DW DAU-45.125DB.TO, DSS.TO, DW.TO DAB-49.116DB.TO, DSS.TO, DW.TO DX-53.130DBK/DP, SDSK/DP, DWK/DP DX-57.146DBK, DSK, DWK DAB-89.215DB, DSS, DW...
-
Page 2: Important Safeguards
Please read this manual carefully before installing and starting up, and store it in a safe place. If you pass on the product to another person hand over this instruction manual along with it. • Do not place the appliance or any of its part near an open flame, cooking or other heating appliance. - Page 3 as a result of repairs carried out by unqualified personnel. In this case neither the guarantee nor any other liability claims will apply. WARNING: To reduce the risk of fire, electric shock or personal injury, unplug or disconnect the • WARNING: Do not use mechanical devices or other appliance from the power supply before...
-
Page 4: Product Features
INSTALLATION • symbol on the product or its packaging indicates that this product is not to be handled as normal household waste but is to be taken to a BEFORE USING YOUR APPLIANCE recycling collection point for electrical and electronic goods. - Page 5 may appear on outside surfaces of glass door. This condensation will disappear when humidity levels Connection should be made via a suitable switched socket drop. For prevention, it is advisable to install the which is easily accessible. For extra safety it is advisable appliance with sufficient ventilation in a dry and/or an to install a residual current device (RCD) with a trip current air-conditioned place.
-
Page 6: Reversing The Door Hinge
○ Remove the bottom hinge ,5 by unscrewing the ○ four lock screws ,6. Be careful to hold the glass door firmly after removing the screws. (Fig. 2) Gently pull down to remove the glass door from the right top hinge and place it on a padded surface to avoid the risk of damage. - Page 7 ○ 8. Recheck and adjust the door alignment by loosening Unscrew and transfer the door supporter ,2 to the ○ ○ the screws ,6and moving the door adapter opposite side. ○ Tighten the screws ,6 after the door is levelled. (Fig. 5) Rotate the glass door 180°and refit the glass door to the opposite side.
-
Page 8: Operating Your Appliance
Set the upper glass door to the designated position and install the two lock screws to connect the door adapter ○ ,14 with the upper glass door and tighten them before the door is leveled. POWER Set the lower glass door to the designated position and To turn the appliance on/off, press and hold the key for 5 reassemble the bottom hinge. -
Page 9: Use And Control - Dual Zone
• (41ºF 68ºF)*****. After the temperature has been set, the display shows +20ºC the current inner temperature. LOWER/RIGHT temperature zone is ideal for storing white and red wine at a setting of +13°C to +20°C (55°F to 68°F). The UPPER/LEFT temperature zone •... - Page 10 • LIGHT To view the set temperature at any time, press the UP or DOWN key, the set temperature will temporarily Used to turn the inner light on/off. flash in the display for 5 seconds. Then the display shows the current inner temperature again. Used to increase (warm) the set temperature by 1°C or 1ºF.
-
Page 11: Dynamic Climate / Silent Mode
The interior light makes it easy to view your wine labels Avoid obstructing the internal fans (located and enhances the display of your collection. Touching the inside on the back panel of the unit). LIGHT mark toggles between 2 modes of operation for the Do not cross contaminate. -
Page 12: General Information
NOTE: Frost may be accumulated on the evaporator if the GENERAL INFORMATION unit is repeatedly opened in a high heat or high humidity location. If this frost pattern does not clear within 24 hours, Operating Noises your unit will require manual defrosting. The unit is cooled by a compressor (refrigeration CARE AND MAINTENANCE aggregate). - Page 13 • Remove the shelf in front of the filter. power is going to be off for a longer period of time, you • Grip the filter and turn it 90°clockwise or need to take the proper steps to protect your contents. anticlockwise to remove.
- Page 14 TROUBLESHOOTING GUIDE (ALL MODELS) PROBLEM POSSIBLE CAUSE REMEDY Appliance is not connected to a power supply. Connect the appliance. The appliance is turned off. Appliance does not Switch on the appliance. The circuit breaker tripped or a blown fuse. operate. Switch on circuit breaker or replace fuse.
-
Page 15: Warranty
• “E0” indicates the communication error for 3 Call for service. zone models. • “E1” or “E2” indicates that the air temperature Display “E0”, “E1”. sensor is failed. • “E3” or “E4” indicates that the defrost sensor in “E2”, “E3”, “E4”, “E5”, “E6”...
Need help?
Do you have a question about the DAB-26.60B.TO and is the answer not in the manual?
Questions and answers