Related Manuals for Draytek VigorSwitch Q60x
Summary of Contents for Draytek VigorSwitch Q60x
- Page 1 VigorSwitch Q60x Unmanaged Switch Quick Start Guide Version: 1.0 (For future update, please visit DrayTek web site) Date: January 22, 2025...
- Page 2 Intellectual Property Rights (IPR) Information © All rights reserved. This publication contains information that is protected Copyrights by copyright. No part may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language without written permission from the copyright holders. The following trademarks are used in this document: Trademarks ...
-
Page 3: Regulatory Information
EU Declaration of Conformity Hereby, DrayTek Corporation declares that the equipment type VigorSwitch is in compliance with EU EMC Directive 2014/30/EU, Low Voltage Directive 2014/35/EU and RoHS 2011/65/EU. The full text of the EU Declaration of Conformity is available at the following internet address: https://fw.draytek.com.tw/VigorSwitch%20Q60x/Document/CE/... - Page 4 Web registration is preferred. You can register your Vigor switch via https://myvigor.draytek.com. Firmware & Tools Updates Due to the continuous evolution of DrayTek technology, all switches will be regularly upgraded. Please consult the DrayTek web site for more information on newest firmware, tools and documents. https://www.draytek.com...
- Page 5 VigorSwitch Quick Start Guide The type of the power cord depends on the country that the switch will be installed. UK-type power adapter EU-type power adapter USA/Taiwan-type power adapter AU/NZ-type Power Adapter If any of these items is found missing or damaged, please contact your local supplier for replacement.
- Page 6 Status Explanation On (Green) The device is connected with 2.5Gbps. On (Amber) The device is connected with 100M/1000Mbps. Port 1 ~ 5 Blinking The system is sending or receiving data through (GbE RJ45) the port. The port is disconnected or the link is failed. On (Blue) The device is connected with 10Gbps.
- Page 7 Use the Ethernet cable(s) to connect None-PoE devices to the Vigor switch. All device ports are in the same local area network. Wall-mounted installation might be required in some cases. Refer to the following figure: 74mm Two screw slots are visible on the bottom side of the switch, which are used for wall-mounting the switch.
- Page 8 This DrayTek product uses software partially or completely licensed under the terms of the GNU GENERAL PUBLIC LICENSE. The author of the software does not provide any warranty. A Limited Warranty is offered on DrayTek products. This Limited Warranty does not cover any software applications or programs.
Need help?
Do you have a question about the VigorSwitch Q60x and is the answer not in the manual?
Questions and answers