Quooker Scale Control Installation Manual page 10

Installatieinstr Scale Control UK.30.362.03.V10 31-01-19 15:29 Pagina 10
Replacing the cartridge
• The cartridge must be replaced before it becomes saturated.
• If the alarm sounds and you are not yet ready to replace the Scale Control
• The Q-shaped button on top of the tank is the on/off switch.
1
3
cartridge, press the wheel on the Scale Control meter once to snooze the
alarm for 72 hours.
2
4
1 Disconnecting
Switch off the tank, but do not unplug
it. Open the boiling-water tap until
the water runs cold. Close the stop
valve on the inlet combination valve.
Close the tap. Disconnect the head by
unscrewing the grooved knob on top
of the Scale Control. Remove the
Scale Control from the kitchen cup-
board.
2 Replacing
Unscrew the lid and replace the old
cartridge with a new one. Screw the
lid onto the container until it clicks
into place. Please note: Ensure that
the red grips of the lid and the
container are aligned.
3 Positioning
Position the Scale Control into the
kitchen cupboard. Screw the head
firmly into the lid of the Scale Control.
4 Flushing
Open the stop valve and the boiling-
water tap until the water runs clear.
Switch on the tank. The Quooker is
ready for use once the water has
heated up.