Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Hans Grohe AXOR Citterio 39452 1 Series
Summary of Contents for Hans Grohe AXOR Citterio 39452 1 Series
- Page 1 Installation Instructions / Warranty Citterio 39452XX1...
- Page 2 Axor Citterio four-hole roman tub set with plate 39452XX1 Technical Data Flow rate @ 45 psi 7.5 gpm per side Handshower 2.5 gpm Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi Recommended hot water temp.: F - 140 *Some municipalities limit the maximum water temperature from the water heater to 120 below.
- Page 3 Installation Instructions The water supply must be turned off at the main prior to installation of this kit. • Remove the plastic plaster shields from the valves and the spout tee. Use a phillips head screwdriver to remove the screws from the white plastic handle snap connectors.
- Page 4 • Remove the brass plug from the end of the high pressure hose. Attach the chrome inner Secu-flex hose. Use the enclosed Hansgrohe Color towelette to clean and lubricate the inner hose. Have a co-worker use the towelette to clean and lubricate the ends of the outer hose.
- Page 5 • Lower the handshower holder onto the handshower tee, feeding the hose assembly under the tub. The hole on the rear of the handshower holder should go over the positioning pin on the handshower holder tee.Install the handshower holder escutcheon over the handshower holder.
- Page 6 • Use a phillips head screwdriver to loosen the screw inside the handle assembly 3 complete turns clockwise. • Pull upward on the cross to remove it. Turn it approximately 60 . Reinsert it. Tighten the screw. • Reinstall the handle.
- Page 7 • Place the spout over the diverter assembly. Insert the diverter knob and tighten. Tighten the set screw, using the enclosed 3 mm allen wrench. • Pull outward on the inner Secu-flex hose. Install a screen washer in the hose end connector. Install the handshower.
- Page 8 User Instructions • Turn the left handle to obtain hot water, the right handle to obtain cold water. • When the water comes on, it will come through the spout. Pull the diverter lever up to divert the water to the handshower. When the water is turned off, the diverter will automatically reset to the spout position.
- Page 10 Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty.
- Page 11 THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: Conditions, malfunctions or damage not resulting from defects in material or workmanship. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse”...
- Page 12 Hansgrohe Inc. 1490 Bluegrass Lakes Parkway Alpharetta GA 30004 770 360 9880 website: www.hansgrohe-USA.com...
Need help?
Do you have a question about the AXOR Citterio 39452 1 Series and is the answer not in the manual?
Questions and answers