Dell POWER VAULT 130T LIBRARY 130T Installation Manual page 7

Figure 2. Interface Connection and Power
Interface Connection and Power
Item Parts Description
Number
1 Power Receptacle
2 Tape Drive Interface Connector
3 Thumbscrew (2x)
2.
Disconnect the power cable from the tape drive.
CAUTION: Disconnect the tape drive interface cable (P980-P983), as described
in the next step, before removing the tape drive. Make sure the cable is out of
the tape drive bay by removing it from the rectangular hole to prevent the
cable from being damaged.
3. Disconnect the tape drive interface cable from the tape drive.
NOTE: The tape drive interface cable (P980-P983) markings face the rear of the tape drive.
Note this orientation when reinstalling the drive interface cable. The connector is keyed but
it is still possible to insert it incorrectly.
4.
Disconnect the SCSI cable connectors and/or terminator from the rear of the drive.
Save the old terminator, if any.
Drive Tray Conversion Instructions 3