Download Print this page

BALAY 3FWS1040 Instructions For Use Manual page 9

Advertisement

Switching off and
disconnecting the
appliance
Switching off the appliance
Press the On/Off button Fig. 1/1.
Refrigerating unit and the light switch off.
Disconnecting
the appliance
If the appliance is not used for
a prolonged period:
1. Switching off the appliance.
2. Pull out the mains plug or switch off
the fuse.
3. Cleaning the appliance.
4. Leave the appliance door open.
Cleaning the appliance
Proceed as follows:
1. Pull out the mains plug or switch off the
fuse!
2. Wipe the door seal with clear water only
and then wipe dry thoroughly.
3. Clean the appliance with lukewarm
water and a little washing up liquid.
The water must not drip onto the
controls or light.
4. After cleaning: reconnect and switch
on the appliance.
Note
Do not use abrasive or acidic cleaning
agents and solvents.
Regularly clean the condensation channel
and drainage hole, Fig. 4, so that the
condensation can flow out. Clean the
condensation channel with cotton buds,
etc.
Water used for cleaning must not run
through the drainage hole into the
evaporation pan.
Tips for saving energy
S Install the appliance in a dry, well
ventilated room, but not in direct
sunlight and not near a heat source
(e.g. radiator, cooker, etc.). If required,
use an insulating plate.
S Open and close the door as briefly
as possible.
S Allow drinks to cool down before
placing in the appliance!
S Occasionally clean the rear of the
appliance with a vacuum cleaner
or paint brush to prevent an increased
power consumption.
en
9

Advertisement

loading