Download Print this page
Toro 161-6718 Installation Instructions
Toro 161-6718 Installation Instructions

Toro 161-6718 Installation Instructions

32in mulch kit for grandstand 32in hdm

Advertisement

Quick Links

32in Mulch Kit
GrandStand® 32in HDM
Model No. 161-6718
Safety
Rear Discharge or Mulch
Grass
WARNING
Without the grass deflector mounted in place,
you and others are exposed to blade contact
and thrown debris. Contact with rotating
mower blade(s) and thrown debris will cause
injury or death.
• Never remove the grass guard from the
mower because the grass guard routes
material down toward the turf. If the
grass guard is ever damaged, replace it
immediately.
• Never put your hands or feet under the
mower.
• Never try to clear the discharge area or
mower blades unless you engage the
parking brake, disengage the power take
off (PTO) lever, shutoff the engine, remove
the ignition key, and wait for all motion
to stop. Also pull the wire off the spark
plug(s).
Ensure that the mower has the rear grass guard to
disperse clippings rearward and down toward the turf
while in rear discharge mode.
To mulch grass clippings, install the baffles on the
mower deck as instructed in the following procedures.
© 2024—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could
seriously injure you or other bystanders.
Remove the key from the ignition switch,
engage parking brake, and pull the wire(s)
off the spark plug(s) before you do any
maintenance. Also push the wire(s) aside so
it does not accidentally contact the spark
plug(s).
Register at www.Toro.com.
Installation Instructions
WARNING
Original Instructions (EN)
Printed in the USA
All Rights Reserved
Form No. 3467-172 Rev A
*3467-172*

Advertisement

loading
Need help?

Need help?

Do you have a question about the 161-6718 and is the answer not in the manual?

Questions and answers

Summary of Contents for Toro 161-6718

  • Page 1 Form No. 3467-172 Rev A 32in Mulch Kit GrandStand® 32in HDM Model No. 161-6718 Installation Instructions WARNING Safety While maintenance or adjustments are being made, someone could start the engine. Rear Discharge or Mulch Accidental starting of the engine could seriously injure you or other bystanders.
  • Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the mower. Screws (5/16 x 1 inch) Flanged nyloc nut (5/16 x 1 inch) Mulch cover plate Install the Mulch Kit.
  • Page 3 Flip up the discharge chute. If the mower has prevent sand or other small objects from being been used, scrape underside of mower deck thrown up through the deck. clean. Tighten all hardware. Remove and retain the existing blades from the Carefully remove the jack stands and lower the unit.