Danfoss HCS6000 User Instructions page 2

A)
Important note; Resetting the unit - To ensure correct operation press reset
button before commencing with programming.
Important note; If no buttons are pressed for two minutes the unit will automatically
go back to run mode. All changes made will be saved.
B) U
SER PREFERENCES
Before programming the thermostat it is recommended that the user preferences as regards
clock display and temperature scale are set. Details of the available user preferences are
shown below:
Clock display: press both SELECT and L buttons and hold for 2 seconds to change
display between AM/PM & 24 hour. Repeat to return to original setting.
Temperature scale: to select between centigrade and farenheit temperature displays,
follow the steps below:
1. Press SELECT and M buttons for 2 seconds to enter temperature display mode
2. Press SELECT and FAN buttons for 2 seconds to change between centrigrade and
farenheit display
3.Press SELECT and M buttons for 2 seconds to change display back to time display
mode prior to programming.
Display actual room temperature: to permanently display actual room temperature press
both SELECT and M and hold for 2 seconds. Repeat to return to time display.
C) S
ETTING THE TIME OF DAY AND DAY OF WEEK
1 Press PROG button to enter programming mode.
2. Press + or – buttons to adjust time of day, if in AM/PM mode remember to ensure that
AM/PM setting is correct.
3. Press PROG to move on to select current day of week.
4. Press + or - button repeatedly until correct day of week is displayed. Day 7 is Sunday.
5. Press PROG button to advance to "Programming event times and temperatures".
D) P
ROGRAMMING EVENT TIMES AND TEMPERATURES
Reminder - The thermostat can be set by the installer to provide 2 or 4 programme events
per day. The thermostat provides 5-day / 2-day Programming with one set of pro-
grammes for days 1-5, (Monday to Friday), and another set of programmes for days 6-7,
(Saturday and Sunday).
Reminder - If thermostat has been set by building owner or installer for 2 events per day,
only 2 events can be programmed.
Reminder – With HCS6000 models, the installer will have set the thermostat for either
heating only or cooling only. When programming these models. Only the service set by the
installer will be available.
Reminder – The time setting of all events are made in increments of 10 minutes.
Setting the time and temperatures events for Days 1-5.
1. Press + or – buttons to adjust event time for event 1.
2
LCD DISPLAYS
SELECT
SELECT
SELECT
SELECT
SELECT
PROG
+
PROG
+
PROG
+
BUTTONS
RESET
L L L L L
plus
M M M M M
plus
then
FAN
plus
then
M M M M M
plus
M M M M M
plus
then
-
or
-
or
-
or