HOMCOM 800-211V70 Assembly Instruction Manual page 7

SPECIAL SAFETY INSTRUCTIONS
● Use only cold water when filling.
● The water level must be between the MAX. and MIN. marks! If the kettle is overfilled,
boiling water may be ejected, which might arise a hazard to the user.
● CAUTION-Ensure that the kettle is switched off before removing it from its stand.
● The kettle is only to be used with the stand provided.
● The appliance must not be immersed.
● The appliance can only be used for household only.
● If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
● Always ensure that the lid is tightly closed.
● The base and exterior of the machine must not become wet.
● This appliance is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
First Use of the Machine
Please read these operating instructions carefully and keep them in a safe place. Before
using for the first time, boil fresh water at least twice in the appliance. Use only water
without any additives or ingredients.
OPERATION
1. Place the machine on a flat surface.
2. Open the kettle by pressing the unlocking button on the handle. Then fill in some water.
The water level can be read off using the water level indicator on the kettle. Please do
not overfill the kettle.
3. Close the lid.
4. Place the kettle on the base. When placing the kettle back to the base, 2 beep sound
can be heard, display will be on at the water temperature.
Boiling:
Default Mode: Touch "Boil/Cancel" button, there will be one sound and display show the
inside water temperature after three blinks, the kettle start to work under "100°C" setting.
When reaching 100 degree C, heating light distinguish. Heater stops.
Temperature setting: Hand touch the temperature + or - button for selecting the desired
cooking temperature (40/50/60/70/80/90/100 degree C). Then touch the "Boil/Cancel"
button to start the boiling. When reaching 100 degree C, heating light distinguish. Heater
stops.
Keep Warm:
Hand touch the temperature + or - button to set the keep warm temperature
(40/50/60/70/80/90degree C). Then touch the " Keep warm" button. Both heating
indicator light and keep warm indicator light will be on. The display show the inside water
temperature after three blinks. Kettle start to work. When the water temperature reach
the setting temperature, then the kettle will stop work after two sounds and then come
into keep warm mood. The heating indicator light will be off.
7