What To Do, If - VOLTA U 416 Operating Instructions Manual

Carrying and Storage
To make the appliance easier to store and carry,
slide the floor nozzle into the tool rail.
Parking System
For storing the suction pipe and nozzle during
short pauses in vacuuming. The bracket on the
nozzle is slid into the parking rail on appliance.

What to do, if ...

... the nozzle is hard to push
Reduce the power setting on the appliance.
Cleaning efficiency is not degraded in this case.
... the motor thermal cut-out has tripped
If the motor is overloaded, e.g. due to a full fil-
ter bag or blocked accessory, the thermal cut-
out shuts down the motor. In this case, switch
off the appliance, unplug from the mains, and
leave the motor to cool down.
Check paper filter bag, suction tube and suction
hose, remove any blockage.
The appliance can be turned on again after
approximately 30 minutes.
... the fuse has blown
The fuse may blow if you use other high power
electrical appliances on the same electrical cir-
cuit at the same time as the vacuum cleaner is
in use.
This problem may be prevented by setting the
electronic power regulator to minimum before
turning on the appliance and increasing the
power setting after switching on.
Your vacuum cleaner is equipped with an
electronic soft start controller that reduces
the start up current of the motor, this avoids
the mains fuse blowing under normal circum-
stances. As a result, at the lowest power set-
ting the appliance may have a start delay of
approx. 4 seconds.
.
... the paper filter is damaged one day and
the motor protection filter is dirty
Remove the motor protection filter, clean (tap
out) and replace.
Insert new paper filter.
31