Setting The Dialling Mode; Recall Mode Select Switch; Headset Stand And Headset - Plantronics STARBASE 2000 Manual

Setting the Dialling Mode

A telephone exchange may
operate either tone or pulse
dialling - the StarBase 2000
telephone supports both. To
set the correct dialling mode,
the Dialling Mode switch (16)
should be set to the correct
position.
The following test may be
carried out if the correct
dialling mode is unknown.
Set switch (16) to tone
Lift the handset, and wait
for the dial tone
Press any button except 0
If the dialling tone can be
clearly heard, then the
dialling mode is set
correctly
If, however, the tone is
distorted, the switch
should be set to pulse
dialling mode.

Recall Mode Select Switch

This function controls the
features available within a
private branch exchange
(PABX). The correct setting for
the recall mode select switch
(15) is dependent upon the
specific PABX that the
telephone is connected to. If in
doubt, please consult your
PABX maintainer.
Two settings are available:
ELR - Earth Loop Recall
TBR - Timed Break Recall

Headset Stand and Headset

The headset stand fits to the
rear of the underside of the
telephone. The two screws
need to be loosened in order to
slide the headset stand into the
correct sockets.
The headset is connected into
the port marked headset (22).
When not in use, the headset
can be placed on the stand.
The StarBase 2000 telephone
supports the complete range of
Plantronics headset styles.
The headset type select switch
(17) indicates which type of
headset is being used. This
switch will usually be in
position A, which is correct for
most Plantronics headsets. If
you use either an SP06 or an
4
SB21 this switch should be set
to position B.
Refer to the headset User
Guide for detailed instruction
on the use of the headset.
If your StarBase 2000
telephone did not come with a
headset, please contact your
supplier for details and
availability.