Mute; Recall Button; Assigning Telephone Numbers To The Memory Keys; Dialling A Stored Number - Plantronics STARBASE 2000 Manual

If your local telephone network
only supports pulse dialling but
you wish, say, to call an
automated service (e.g.
telephone banking) you can use
the tone key to accomplish this:
Lift the receiver, and dial
the number
Press the tone key; tones
are now generated
When the call is ended, the
telephone automatically
reverts to pulse dialling
mode.

Mute

To switch off the microphone,
the 'mute' key (9) can be
pressed. If selected, the
indicator light near the key lights
up, and the microphone of the
handset and the headset are
switched off. On pressing the
key again, the mute is cancelled.

Recall Button

The recall key (6) is used by
PABX systems, and on digital
exchanges. Contact your
service provider for details of
the features available. One
common use of the recall key
on PABX systems is to
transfer calls to another
extension.
If you wish to transfer a call to
another extension, the recall
key should be pressed, and
the extension number to
transfer the call to dialled.
Then hang up.
Assigning Telephone Numbers
to the Memory Keys
The StarBase 2000 headset
telephone can store 19
telephone numbers. You can
use up to 24 digits for each
memory location.
To store telephone numbers:
1) Lift the handset
2) Press the red programming
key (5)
3) Press the memory key (2)
that you wish the number
to be associated with
4) Dial the desired telephone
number
5) Press the programming key
(5) again
6) To put additional numbers
into memory, repeat steps
2 to 5
7) Replace the handset.
The memory locations (2) can
be named by carefully lifting
the memory number card
cover and writing a name
against it.
6

Dialling a Stored Number

To dial a telephone number that
has been stored in one of the
memory locations, lift the
handset, or press the headset
key (10), and wait for the
dialling tone. Press the
memory key (2) that the
required telephone number
was stored under. The number
will be redialled automatically.
Changing a Stored Number
Stored numbers can simply be
'overwritten' by following steps
2-5 as outlined previously.
* and # Keys
These keys provide access to
certain features provided by
modern public exchanges and
PABX. Details should be
obtained from the network
operator or PABX supplier.