Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Plantronics Manuals
  4. Headsets
  5. Stereo SupraPlus USB
  6. Setup manual

Plantronics SupraPlus Wireless Headset System Setup Manual

Plantronics wireless headset system setup guide
Hide thumbs Also See for SupraPlus Wireless Headset System:

Advertisement

Quick Links

Download this manual See also: User Manual
4 Easy Steps
The fastest way to set up your Plantronics
®
SupraPlus
Base Power
Adapter
SupraPlus
Wireless
Headset
Base
Wireless Headset System
HL10
Automatic
Handset Lifter*
SupraPlus
Wireless
Headset
Plantronics SupraPlus Wireless
*Not included in all confi gurations
S
G
E T U P
U I D E

Advertisement

loading

Related Manuals for Plantronics SupraPlus Wireless Headset System

Summary of Contents for Plantronics SupraPlus Wireless Headset System

  • Page 1 4 Easy Steps The fastest way to set up your Plantronics ® SupraPlus Wireless Headset System Base Power Adapter SupraPlus Wireless Headset Base HL10 Automatic Handset Lifter* SupraPlus Wireless Headset Plantronics SupraPlus Wireless *Not included in all confi gurations E T U P U I D E...
  • Page 2 LANTRONICS Monaural Noise-Cancelling Headset* *One model included in each package–all available models shown. Base Please refer to the separate Safety Instructions for important product safety information prior to installation or use of the product. SupraPlus Wireless With Automatic Handset Lifter** Adds: HL10 Automatic Handset Lifter **Automatic Handset Lifter is bundled with certain SupraPlus Wireless confi gurations and also available...
  • Page 3 DJUST FIT A. Adjust the Headband 1. To adjust the headband, lengthen or shorten the band until it fi ts comfortably. The clickstop feature keeps the headband securely adjusted. Position the headset receivers so that the foam cushions sit comfortably over the center of your ears.
  • Page 4 ONNECT It is important for correct and safe operation that the base cord is installed into the proper jack of your telephone. Follow these instructions carefully, especially if your telephone has two jacks where the handset was attached. Be sure to note or mark which jack was used for the handset Use Confi guration A if: You will use the Automatic Handset Lifter or…...
  • Page 5 Use Confi guration B if: You will NOT use the Automatic Handset Lifter and… Your phone has built-in headset functionality (a Headset button). Confi guration B 1. Plug the short BLACK Phone Cable that is pre-installed on the Headset Base into the Headset port [C] on the desk phone.
  • Page 6 ONNECT A. Connect Headset Base to power outlet . Plug the Base Power Adapter into a wall outlet, then plug the power cord into the labeled connector on the bottom of the Headset Base. The front of the Headset Base will turn on. (See illustration on page 13.) B.
  • Page 7 NSTALL UTOMATIC Why use a handset lifter? a headset with your desk phone. It lets you answer and end calls without being near your phone. The HL10™ Automatic Handset Lifter is included with certain SupraPlus Wireless confi gura- tions and is also available separately. See www.plantronics.com/SupraPlusWireless for a complete list of accessories.
  • Page 8 B. Determine Lifter position and height setting . Set the Lifter Height Switch to the lowest setting. Lifter viewed from back . While wearing your headset slide the Handset Lifter Arm under the handset until the lifter base touches the side of the phone. Slide the Lifter up to where it nearly touches the handset earpiece.
  • Page 9 C. If you do not hear a dial tone If you do not hear a dial tone, the Lifter may not be raising the handset high enough or the Confi guration Dial may need adjusting. Check the Lifter height adjustment by moving the Lifter Height Switch to a higher position.

  • Page 10: Powering The Headset On And Off

    SING YOUR WITH YOUR DESK PHONE For your safety, do not use headset at high volumes for extended periods of time. Doing so can cause hearing loss. Always listen at moderate levels. For more information on headsets and hearing visit: www.plantronics.com/healthandsafety If your desk phone has a volume control, set it to mid-range.
  • Page 11 Adjust Listening Volume While on a call, adjust the listening volume by using the Listening Volume Switch on the back of the base. Listening Volume Switch Position 1 = Loudest Position 4 = Softest To Fine Tune Listening Volume On the headset, press the (+) on the Listening Volume Button to increase the volume.
  • Page 12 If the sound quality is poor or background noise is evident after these adjustments re-adjust the confi guration dial for better quality. See page 9. Set the IntelliStand The SupraPlus Wireless IntelliStand feature allows you to choose how to activate your head- set when answering or making a call.

  • Page 13: Base Indicator Lights

    UPRA IRELESS Base Indicator Lights Tones Out of Range Warning: If you walk out of range of your base, your headset will issue audible tones at its operating limit. If you are on a call, you will hear two tones when reaching edge of range, and again when back in range.
  • Page 14 ROUBLESHOOTING AND I can’t hear a dial tone at the headset. • Make sure your headset is charged. • Press the Call Control Button on your headset. • Make sure the Talking (solid green light) on top of the base is illuminated. If not, the headset lost subscription and needs to be re-subscribed.
  • Page 15 Additional Information and Support Additional Information Additional Information including an Interactive Quick Start Guide, Product Information and Accessories including the HL10 Automatic Handset Lifter and Online Indicator Light can be found at www.plantronics.com/ SupraPlusWireless. Telephone Support Telephone Tech Support at 800-544-4660 Ext.
  • Page 16 FCC REQUIREMENTS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.