NAD T175 HD Owner's Manual page 33

Tone Controls: Tone Defeat: Off
Display Setup: Set "Line 2" to "Volume"
Picture Controls: Aspect Mode – Stretch
5 With the above settings, scroll to "A/V Presets" from the SETUP MENU
page. Use [ ] to access "A/V Presets" menu.
USING THE T 175 – SETUP MENU
6 At "A/V Presets" page, set "Preset: 2" to the following conditions - use [
to select "Yes" or "No" and press [ENTER] to confirm selection and move to the
next setting
While at "Save Current Setup to Preset" menu line, use [
settings above to "Preset 2". When you recall "Preset 2" using the remote
control (for HTRC 1, "A/V PSET" + "2"), the above preset values allocated
at "Preset 2" (preset settings as shown in the OSD captures at Step 4) will
be recalled and effected at the current source.
Note that "Speaker Setup" is set to "No". At this condition, there will be
no "Speaker Setup" values that will be effected at "Preset 2". The "Speaker
Setup" settings that will be applied at "Preset 2" will be the last or current
"Speaker Setup" settings which in this sample are the same "Speaker
Setup" settings shown above in Step 1.
7 You can setup up to 5 Presets. These same Presets can also be
associated/defaulted to each Source in the "Source Setup (Normal
View)" window as below
In the above example, "Preset 1" settings are allocated for Source 1.
Whenever Source 1 is accessed, the "Preset 1" settings will be applied to
Source 1. You can still manually override the assigned Preset allocation in a
specific Source with another Preset setting/number by way of pressing the
appropriate remote control buttons.
RECALLING PRESETS
You may recall a Preset at any time using the HTRC 1 remote control.
Press the HTRC 1's A/V PSET key and then the numeric key 1-5
corresponding to the desired preset number. The newly recalled Preset will
then manifest or replace the previous Preset (if any).
OPERATION
]
] to save the