Zone Controls - NAD T175 HD Owner's Manual

ZONE CONTROLS

Depending on the settings made at the separate 'Zone Setup' menu under
the 'Setup Menu' section discussion, the applicable Zone can be configured
and managed via this 'Zone Controls' window.
Select 'On' to activate the applicable Zone. When activated, the Source input
for the particular Zone can be allocated by selecting through the following
inputs – All enabled Sources, Front Input, Media Player, Tuner and Local.
Select 'Local' as your selected Zone's Source input if you wish to enjoy the
same source as the main Zone and allow simultaneous listening, but with
full separate volume levels.
If a Zone is set to 'Off, ' it is deactivated or powered off.
'Volume' refers to the adjustable secondary Zone 2 Volume level that can
be increased or decreased using the
panel's corresponding navigation buttons.
When a Zone is activated, a corresponding Zone number is illuminated
at the VFD. Zone 2 is always available to be configured at 'Zone Controls'
menu. For Zone 3 and Zone 4 to become available at the 'Zone Controls'
window, their corresponding 'Mode' in the 'Zone Setup' menu under the
'Setup Menu' section should be set to 'Zone (Audio Only). '
NOTE
The ZR 4 remote control will only control Zone 2 applications. Zone 3
and Zone 4 could be configured and managed at the appropriate Zone
OSD menu using the front panel navigations buttons as well as the
corresponding keys on the HTRC 1 remote control.
buttons of the HTRC 1 or front
OPERATION
USING THE T 175 – MAIN MENU
17