Specifications; Tone Controls - NAD C 725BEE Owner's Manual

PREAMPLIFIER SECTION
line level inputS (mp, cd, diSc, aux, tape)
Signal / noise ratio pre-amp out, A-weighted
line level outputS

tone controlS

trigger out
POwER AMPLIFER SECTION
Input impedance (R and C)
Input sensitivity
Maximum input signal
Signal / Noise ratio A-weighted
Frequency response
THD + Noise, SMPTE IM
Output impedance, Pre-out
Output impedance, Record Out
Maximum output level, Pre-out
Maximum output level, Record Out
Treble
Bass
Output resistance
Output current
Output voltage
Continuous output power into 8 Ω
Rated distortion (THD 20 Hz - 20 kHz)
Clipping power
IHF Dynamic headroom - 8 Ω
4 Ω
IHF dynamic power, 8 Ω
4 Ω
2 Ω
Damping factor (ref. 8 Ω, 1 kHz)
Input impedance (R & C)
Input sensitivity (rated output into 8 Ω)
Voltage gain
Frequency response 20 Hz - 20 kHz
Signal/noise ratio, A-weighted
THD + Noise
SMPTE IM
IHF IM
Headphone output impedance
22 kΩ + 100pF
250 mV (ref. rated power)
6V
95 dB
1
107 dB
<±0.3dB (20 Hz - 20 kHz, Tone defeat on)
<±0.3dB (20 Hz - 20 kHz, Tone defeat off )
< 0.01 % at 5 V out
80 Ω
Z+ 1 kΩ
11 V
11 V
±5 dB at 10 kHz
±8 dB at 100 Hz
75 Ω
150 mA
12 ±1 V
2x50 W (17 dBW)

0.02 %
61 W (maximum continuous power per channel 4 Ω and 8 Ω)
+3.1 dB
+4.7 dB
102 W(20.0 dBW) (maximum short term power per channel)
148 W(21.7 dBW)
205 W(23.1 dBW)
>110
20 kΩ +1 nF
730 mV
28.7 dB
±0.2 dB
102 dB
 <0.02 %
<0.02 %

 <0.01 %
220 Ω
REFERENCE

SpecificationS

1