RHENINGHAUS SSA0002 Instruction Manual

Download this manual

SBR safe blade removal

0. Lift the sharpening unit up

1. Unscrew and remove blade cover disc.

2. Position SBR in contact with the blade by fitting extractor

shaft in the blade central hole

3. Screw the two knobs of the SBR in correspondence of the two

holes on the blade

4. Seize the SBR central handle and unscrew it by holding the

aluminium central bar to keep its position

5. It is now possible to take off the blade

6. Carry out cleaning of the machine and of the rear part of the

blade

7. Position the blade back in its seat and screw the SBR central

handle tight

8. Unscrew the two knobs on the aluminium central bar to

remove the SBR tool.

Instructions manual

SSA0002

RHENINGHAUS S.r.l.

Strada del Cascinotto, 139/39L – 10156 TORINO - ITALY

Tel. ++39 011 2237514 – Fax ++39 011 2735109

e-mail:

info@rheninghaus.com

internet: www.rheninghaus.com

Need help?

Do you have a question about the SSA0002 and is the answer not in the manual?

Page 1 SBR safe blade removal Instructions manual SSA0002 0. Lift the sharpening unit up 1. Unscrew and remove blade cover disc. 2. Position SBR in contact with the blade by fitting extractor shaft in the blade central hole 3. Screw the two knobs of the SBR in correspondence of the two holes on the blade 4.
Page 2 WIRING DIAGRAM...
Page 3 1 INTRODUCTION We thank you to have chosen us. The machine you have chosen is built by using quality materials and up-to-date technologies. Your safety as well as that one of your customers and users is very important: the following instructions allow a safe machine use.
Page 4 2.7 MAIN SAFETY DEVICES It is necessary that blade is cleaned and grease is very well removed. Blade-cover: it safeguards blade rim along all the circle part which is not Ensure that the machine is turned off then lift the sharpening unit up and rotate it used to cut.
Page 5 Bring the platform at starting position, towards operator; lift the food-pusher and 4 INSTALLATION put the product to be cut on the platform, in contact with the regulator plate stop 4.1 TRANSPORT product with food-pusher, turn regulator knob till to obtain the required thickness;...