Solight WM57 Manual

EN WM57
Wifi Smart LED light strip
Dear customer, thank you for purchasing our product. Please read the following instructions carefully and follow them to
serve you safely and to your full satisfaction. This will prevent misuse or damage. Avoid unprofessional handling of this
product and always observe the electrical appliance usage guidelines. Keep the instruction manual carefully. The light
source of this luminaire is non-replaceable, at the end of its service life the entire luminaire must be replaced and disposed
of in a designated place. The fixture can be controlled via remote control, mobile app, Amazon Alexa and Google Home.
P o w er: AC 230V / DC 12V, 2000mA
N O T IC E
1. First, unpack the lighting from the box and fully unwrap it. Do not turn on the lighting unless the coil is fully unwound.
2. This lighting heats up during use. Therefore, do not place it near other heat sources or cover it with anything.
3. Do not use the lighting if it is damaged in any way, including cable insulation, if it has been subjected to a short circuit
or a high voltage pulse.
4. Use only the supplied power adapter. Never plug the light or its parts directly into the mains or try to connect it to
another product.
5. The product meets IP65 protection class and is suitable for outdoor and indoor use.
Attention, the adapter meets protection class IP20!
6. For maintenance, use a damp cloth and always clean when unplugged. Allow the lighting to dry thoroughly before use.
7. Do not interfere with the wiring. Improper intervention may result in short circuit, fire or personal injury.
8. Disconnect the lighting from the mains when not in use.
9. Protect the environment. Dispose of unusable product in designated collection facilities. Do not dispose of in normal
household waste.
IN ST A LLA T IO N
1. Clean and dry the surface to which you intend to stick the tape.
2. Remove the adhesive tape from the back and stick the LED strip in
the desired location
.
3. When positioning the LED strip, do not press directly on the LED.
The LED strip can be shortened as required at the marked points.
To ensure uniformity of illumination, do not connect more than 5m length
LED strip on one power adapter.
C O N N EC T IO N S
1. Plug the white connector from the LED strip into the WIFI module. The small
arrow on the connector must be plugged into the place marked with the +
symbol.
2. Plug the WIFI module into the power adapter and the power adapter into the
mains.
C O N T R O L
The LED strip can be controlled with an infrared remote control or via the Smart Life app, Tuya, Amazon Alexa and
Google Home.
The remote must be pointed at the receiver sensor included in the WIFI module. There must be a direct line of sight to
the sensor from the remote.
B u tto n co n tro l
C : Setting the light scene
: Press On/Off
M : Music mode