Solight WO772 Quick Start Manual

Led solar light

Advertisement

Available languages

Available languages

EN
Solight WO772 LED solar light
Dear customer, thank you for purchasing our product. Please carefully read and abide by the following instructions to ensure
that this product is used safely and to your complete satisfaction. This will also help avoid any improper use or damage. Prevent
any unskilled handling of the device and always follow the principles of use for electrical appliances. Store these instructions in a
safe place.

Specification

Voltage
Rated power
Discharge current
Working time
Max. detection range
Max. detection angle
IP Protection
Battery type
Solar panel
Working temp. / humidity

Installation

1. Select a suitable mounting location so that the panel is exposed to sunlight
2. Mount the lamp holder to the wall with screws. Recommended height is 2–2.5 m above the ground (Fig. A)
3. Slide the light onto the holder (Fig. B)
4. Secure with a screw (Fig. C)
5. Set the position of the light to lighten the desired location
6. Leave the light off and charge it for at least 10 hours
7. Switch on the light with the switch on the bottom.
8. Set the lighting time and light sensitivity with the TIME and LUX knobs, see below for more information.
9. PIR sensor, light and solar panel can be adjusted at different angles.

Sensor and lighting duration settings

Using the rotary knobs on the top of the reflector, you can set the lighting time (TIME) and set the
sensitivity depending on the ambient lighting conditions. The time can be set from 10 to 60 seconds. If
motion is detected more than once within a single time interval, the time is added up.

Charging and maintenance

Charging takes place automatically on sunny days. A full charge takes about 10 hours during summer days. In winter about 3
days. Keep the solar panel clean for maximum efficiency. If you need to replace the battery, first remove the reflector from the
holder. Then unscrew the two screws and open the battery cover. Replace the battery, replace the cover, tighten the screws,
and slide back onto the bracket.
The light source of this luminaire is not replaceable; when the light
source reaches its end of life the whole luminaire shall be replaced.
Manufacturer: Solight Holding s.r.o., Na Brně 1972,
Hradec Králové 500 06
DC 3,7V
8W
2,2A max.
1 hodina (max. 120 sepnutí)
8m
110°
IP44
1x 18650 Li-Ion 2000mAh
5V / 1,5W – 300mA
-20°C to +50°C

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WO772 and is the answer not in the manual?

Questions and answers

Summary of Contents for Solight WO772

  • Page 1 The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. Manufacturer: Solight Holding s.r.o., Na Brně 1972, Hradec Králové 500 06...
  • Page 2 Nabíjecí LED solární světlo Solight WO772 Vážený zákazníku, děkujeme za zakoupení našeho výrobku. Pozorně si přečtěte následující pokyny a dodržujte je, aby vám sloužil bezpečně a k plné spokojenosti. Předejdete tak jeho nesprávnému použití či poškození. Zabraňte neodborné manipulaci s tímto přístrojem a vždy dodržujte zásady používání...
  • Page 3 Nabíjací LED solárne svetlo Solight WO772 Vážený zákazník, ďakujeme Vám za zakúpenie nášho výrobku. Pozorne si prečítajte nasledujúce pokyny a dodržujte ich, aby Vám slúžil bezpečne a k plnej spokojnosti. Predídete tak jeho nesprávnemu použitiu či poškodeniu. Zabráňte neodbornej manipulácii s týmto prístrojom a vždy dodržujte zásady používania elektrospotrebičov.

Table of Contents