NOTE
The electrical parts work only when the ignition switch is
in position " ".
o
p
1) LIGHT SWITCH (
-
CAUTION
Before operating the light switch, make sure that the dim-
mer switch (
-
) is in position "
When the light switch is in position "
the switch is in position "
board light are on; when the switch is in position "
parking lights, the dashboard light and the low beam are on.
The high beam can be operated by means of the dimmer
switch (
-
).
2) START PUSH BUTTON (
When the start push button " " is pressed, the starter makes
the engine run. For the starting, see p. 31 (STARTING).
3) ENGINE STOP SWITCH (
Do not operate the engine stop switch "
conditions.
This is a safety or emergency switch. With the switch in po-
sition " ", it is possible to start the engine; the engine can
be stopped by moving the switch to position " ".
•
-
) (
not provided)
".
•
", the lights are off; when
", the parking lights and the dash-
)
-
)
WARNING
-
" in running
", the
With stopped engine and ignition switch in position " ",
the battery may run down.
When the vehicle has come to a halt, stop the engine, and
move the ignition switch to position " ".
CAUTION
use and maintenance Scarabeo 125 - Scarabeo 150
17