Table of Contents
Advertisement
NOTE
Be sure to maintain the same ori-
entation as the old bulb when you install
the new bulb. Do not try to force the bulb,
it will go easily if it is properly oriented.
N
Insert the new bulb into its socket (8), en-
suring that the tabs are correctly posi-
tioned.
N
Replace the clip (7).
N
Connect the bulb electric terminal (6).
N
Replace the rubber boot (5).
LOW BEAM BULB (CENTRAL LOWER
POSITION)
N
Place the vehicle on the stand, see p. 71
(POSITIONING THE VEHICLE ON THE
STAND).
N
Working from the central underside of
the front part of the fairing, pull back the
rubber boot (9) with your fingers.
CAUTION
To extract the bulb electric connector,
do not pull its electric wires.
N
Grasp the bulb electric connector (10),
pull it and disconnect it from the bulb (3).
N
Rotate the bulb socket (11) counter-
clockwise and extract it from the reflec-
tor.
N
Remove the bulb (3) from the seat.
NOTE
Be sure to maintain the same ori-
entation as the old bulb when you install
the new bulb. Do not force the bulb, it will
go easily if it is properly oriented.
N
Correctly install the new bulb (3) into the
bulb socket (11).
N
Position the bulb socket (11) in the re-
flector and rotate it clockwise.
N
Connect the bulb electric connector (10).
N
Replace the rubber boot (9).
Carefully read p. 111 (BULBS).
NOTE
Before changing a bulb, check
the fuses, see p. 104 (CHANGING FUS-
ES).
N
Place the vehicle on the stand, see p. 71
(POSITIONING THE VEHICLE ON THE
STAND).
N
Unscrew and remove the screw (12).
NOTE
While removing the lens, use ex-
tra care to be sure that you do not break
the key.
N
Remove the lens (13).
NOTE
Upon reassembly, position the
lens correctly in its seat.
CAUTION
Tighten the screw (12) moderately and
with care to avoid damaging the lens.
N
Push the bulb (14) in slightly and rotate it
counterclockwise.
N
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with
their guides in the socket.
N
Correctly install a new bulb of the same
type.
NOTE
If the bulb socket (15) has fallen
out of its seat, replace it correctly, ensuring
that the slot in the reflector aligns with the
screw hole in the body of the turn signal
lamp.
use and maintenance RSV mille
113
Advertisement
Table of Contents
