Table of Contents
Advertisement
CAUTION
Once it has been removed, store the
battery in a safe place and keep it away
from children. Even a completely
sealed, maintenance free battery can
present a danger of injury.
N
Replace the battery braket (9).
N
Screw the screw (8).
N
Replace the rider saddle, see p. 94 (RE-
MOVING THE RIDER SADDLE).
Carefully read p. 106 (BATTERY).
Your vehicle is equipped with a sealed
maintenance free battery that does not re-
quire the check of the level battery.
Carefully read p. 106 (BATTERY).
WARNING
This battery is completely sealed. Do
not attempt to remove the caps.
There is never any need to add water to
this battery. Attempting to remove the
caps will destroy the battery and could
lead to injury through the spillage of
caustic electrolyte. Recharge the bat-
tery according to the table below.
N
Remove the battery, see p. 107 (REMOV-
ING THE BATTERY).
108
use and maintenance RSV mille
WARNING
The battery gives off noxious and explo-
sive gases; keep it away from flames,
sparks, cigarettes and any other source
of heat.
During recharging or use, make sure
that the room is properly ventilated and
avoid inhaling the gases released dur-
ing the recharging.
N
Connect the battery charger to the bat-
tery.
N
Charge the battery using a battery charg-
er with a current capacity of no greater
than 1/10th the capacity of the battery,
see p. 118 (TECHNICAL DATA).
N
Charge at voltage at amperage and time
stated below.
Voltage
Recharge
(amp)
Normal
1.2
Quick
12
WARNING
Wait for 5 or 10 minutes after you have
finished charging the battery before re-
installing it, the battery continues to
pro-duce gas for a short period of time
after the charger is removed.
Carefully read p. 106 (BATTERY).
N
Check the charge of the battery, see be-
side (RECHARGING THE BATTERY).
Time
N
Make sure that the ignition switch (1) is
(hours)
in the "
" (OFF) position.
N
Remove the rider saddle, see p. 94 (RE-
8 – 10
MOVING THE RIDER SADDLE).
0.5
N
Unscrew and remove the screw (8).
N
Remove the battery braket (9).
N
Put the battery (10) in its container.
N
Connect, in order, the positive red (+) ca-
ble terminal (4) and negative (–) cable
terminal (5).
N
Cover the terminals of the cables and of
the battery with neutral grease or Vase-
line.
N
Replace the red protection rubber (3).
N
Replace the battery braket (9).
N
Screw and tighten the screw (8).
N
Replace the rider saddle, see p. 94 (RE-
MOVING THE RIDER SADDLE).
Advertisement
Table of Contents
