HOMCOM 800-158V91 User Manual page 6

19. Keep at least six inches of space around all sides of the machine, ensuring the
cooling air can circulate freely.
20. Do not use mechanical equipment or other means to accelerate the defrosting
process – only use methods recommended by the manufacturer.
21. Do not damage the ice machine refrigeration tube.
23. It is forbidden to clean the ice machine with flammable liquid – this is a fire or
explosion hazard.
24. It is forbidden to store explosives such as gasoline, combustion-supporting sprays or
other flammable gases or liquids in this appliance.
25. Under no circumstances should the ice machine be inclined more than 45 degrees.
26. When the machine is working, it is strictly forbidden to touch the evaporator by hand.
Troubleshooting
If the machine breaks down, please wait for the machine to stop automatically. Use the
methods in the table below to solve any issues. Do not disassemble, inspect or repair the
machine without professional guidance.
This machine has a self-checking function. If an error occurs, the 'ice full' and 'add water'
indicator will flicker alternately – the ice maker will stop working.
phenomenon
The machine
does not respond
'Add water
indicator' light is
on
'Ice full indicator'
light is on
Ice cubes stick
together
Ice cubes smaller
than usual size
The machine is
working properly
but does not
make ice
Cause
No power
There is no power in the power
jack
The power cord is not properly
plugged in
Power cord is damaged
Not enough water
Poor induction of the water
shortage sensor
Ice basket is full
Poor induction of ice full sensor
Ice making environment or
water temperature is too low
Ice making environment tor
water temperature is too high
Refrigeration pipe blockage
Refrigerant leak
Check the power supply
Check the power cord
connection
Ensure the machine is
properly plugged in
Call an authorized technician
for repair
Add water and restart the
machine
Turn off the machine, wait two
minutes, then restart
Remove ice cubes from the
basket
Clean the induction probe
Replace the water. The
temperature should be
between 45-90℉
Replace the water. The
temperature should be
between 45-90℉
Call an authorized technician
for repair
Call an authorized technician
for repair
6
Solution