ZyXEL Communications P-870HN-51B - V1.0 Manual page 78

Chapter 5 WAN Setup
The following table describes the labels in this screen.
Table 15 WAN Configuration: PPPoE or PPPoA
LABEL
PPP User Name
PPP Password
PPPoE Service
Name
Authentication
Method
Enable Fullcone
NAT
Dial on Demand
Inactivity
Timeout
Use Static IPv4
Address
IPv4 Address
Enable PPP
Debug Mode
78
DESCRIPTION
Enter the user name exactly as your ISP assigned. If assigned a name
in the form user@domain where domain identifies a service name,
then enter both components exactly as given.
Enter the password associated with the user name above.
Type the name of your PPPoE service here.
This field is not available for a PPPoA connection.
The ZyXEL Device supports PAP (Password Authentication Protocol)
and CHAP (Challenge Handshake Authentication Protocol). CHAP is
more secure than PAP; however, PAP is readily available on more
platforms.
Use the drop-down list box to select an authentication protocol for
outgoing calls. Options are:
AUTO - Your ZyXEL Device accepts either CHAP or PAP when
requested by this remote node.
PAP - Your ZyXEL Device accepts PAP only.
CHAP - Your ZyXEL Device accepts CHAP only.
MSCHAP - Your ZyXEL Device accepts MSCHAP only. MS-CHAP is the
Microsoft version of the CHAP.
Select this option to enable full cone NAT on the ZyXEL Device.
Select this check box when you do not want the connection up all the
time and specify an idle time-out in the Inactivity Timeout field.
Specify an idle time-out when you select Dial on Demand. The
default setting is 0, which means the Internet session will not timeout.
A static IPv4 address is a fixed IP that your ISP gives you. A dynamic
IP address is not fixed; the ISP assigns you a different one each time
you connect to the Internet. Select this if you do not have a dynamic
IP address.
Enter the static IP address provided by your ISP.
Select this option to display PPP debugging messages on the console.
P-870HN-51b User's Guide