The Internet Connection Screen - ZyXEL Communications P-870HN-51B - V1.0 Manual

Table 11 DSL PTM Interface Configuration (continued)
LABEL
Peak Cell Rate Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find
Sustainable
Cell Rate
Maximum
Burst Size
Select
Connection Mode
Enable Quality Of
Service
Back
Apply/Save

5.5 The Internet Connection Screen

Use this screen to change your ZyXEL Device's WAN settings. Click Network >
WAN > Internet Connection. The summary table shows you the configured
WAN services (connections) on the ZyXEL Device.
To use NAT, firewall or IGMP proxy in the ZyXEL Device, you need to configure a
WAN connection with PPPoE or IPoE.
P-870HN-51b User's Guide
DESCRIPTION
the Peak Cell Rate (PCR). This is the maximum rate at which the
sender can send cells. Type the PCR here.
This field is not available when you select UBR Without PCR.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that
can be transmitted. Type the SCR, which must be less than the PCR.
Note that system default is 0 cells/sec.
This field is available only when you select Non Realtime VBR or
Realtime VBR.
Maximum Burst Size (MBS) refers to the maximum number of cells
that can be sent at the peak rate. Type the MBS, which is less than
65535.
This field is available only when you select Non Realtime VBR or
Realtime VBR.
Select Default Mode to allow only one WAN service over a single
virtual circuit.
Select VLAN MUX Mode to allow multiplexing of multiple protocols
over a single virtual circuit. You need to assign a VLAN ID and priority
level to traffic through each WAN connection. All WAN connections
share one MAC address.
Select MSC Mode to allow multiple WAN services over a single virtual
circuit. Each WAN connection has its own MAC address.
This field is not available if you select PPPoA or IPoA as the DSL link
type. The ZyXEL Device uses Default Mode automatically for PPPoA
or IPoA.
Select this option to activate QoS (Quality of Service) on this interface
to group and prioritize traffic. Traffic is grouped according to the VLAN
group.
This field is not available when you select CBR or Realtime VBR.
Click this button to return to the previous screen without saving any
changes.
Click this button to save your changes and go back to the previous
screen.
Chapter 5 WAN Setup
73