FIELD
Work Ports
Enter the number of ports that to be aggregated.
If you select Enable in the LACP field, then enter any number greater than
0 and smaller than the total number of the trunk ports. The excess ports are
in standby and can be aggregated if any of the other ports fail.
If you select Disable in the LACP field, then the number of ports must be
the same as the number of the trunk ports.
By default, the total number of trunk ports is displayed.
Add
Select a port number on the right selection box and click Add to add the
port to the trunk group on the left.
Any ports that remain on the right are ports not assigned to any trunk
groups.
Remove
Select a port number on the left selection box and click Remove to remove
the port from the trunk group.
7.3
Viewing Static Trunk Group Information
The Aggregator Information screen displays static trunk groups (with the LACP
feature).
Click Administrator, Trunking and then the Aggregator Information tab. A screen
displays as follows.
Figure 7-2 Trunking: Aggregator Information.
The following table describes the fields in this screen.
FIELD
Group Key
This field displays the trunk group number.
Port Trunking
Table 7-1 Trunking: Aggregator Setting
Table 7-2 Aggregator Information
Dimension ES-2008 Ethernet Switch
DESCRIPTION
DESCRIPTION
7-3