Download Print this page

BRIO CLTL420 User Manual

Top-load water cooler

Advertisement

Quick Links

R
USER'S MANUAL
Top-Load
Water Cooler
MODEL NO.
CLTL420
Thank you for purchasing a Lago water cooler.
Please read this user's manual thoroughly for
using the water coolers safely and appropriately.

Advertisement

loading
Need help?

Need help?

Do you have a question about the CLTL420 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for BRIO CLTL420

  • Page 1 USER’S MANUAL Top-Load Water Cooler MODEL NO. CLTL420 Thank you for purchasing a Lago water cooler. Please read this user’s manual thoroughly for using the water coolers safely and appropriately.
  • Page 2 SAFETY PRECAUTIONS • Plug in the dispenser in the way described in this manual. • In accordance with these instructions, the dispenser must be properly located and installed before use • Use only water. Do not use co ee, tea or other beverages. •...
  • Page 3 Cold Water Faucet (Blue Lever) and Hot Water Faucet (Red Lever) Hot | Room | Cold Press the Blue Lever for Cold Water and Red Lever for Hot Water, respectively. Place a cup directly below a faucet and depress the correct lever ,but be careful using the hot water.
  • Page 4 Remove the Air inside the Hot Water Tank After installing a bottle, remove the air inside the Hot Water Tank by pressing and holding the Hot Water Lever as shown in the following gure until water starts to come out of the water outlet.
  • Page 5 TROUBLESHOOTING Please check the following items prior to asking for repair Troubles Things to check Troubleshooting Is the bottle empty? Replace with a new bottle. Water does not come out (Cold Water & Hot Water) Is the air inside the Tank removed Press and hold the lever until the water completely? comes out through Hot Water Faucet.
  • Page 6 About 1.1ℓ (Stainless Steel Tank) * For the improvement of product Brio reserves the right to change specifications without notice. * You must confirm the correct voltage(V) and frequency(Hz) and then plug to the outlet. Check the proper voltage in the back of dispenser.