MELICONI EASY 300 Instructions

Remote control for TV sets SONY ready to use
Thank you for choosing a Meliconi remote control.
This remote control, after inserting the batteries, is normally ready for use as it is already set at the
If problems are found to command the TV, or some functions do not produce the desired effect, to follow the instructions
The EASY 300 remote control is designed to command a
The MELICONI remote control reproduces infrared signals corresponding to the original; the functions that operate in radio
frequency (e.g. voice commands and pointers) are not supported.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
The remote control and batteries should not be exposed to excessive heat such as sunlight, fire
or the like.
The product is not a toy. Keep out of reach of children or domestic animals.
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the
package. Insert with the correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the
continuously until the button is released. If the light is off, the inserted batteries are low, therefore
they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
If problems are found to command the TV, or some functions do not produce the desired effect, please proceed as follow:
• Press and hold for at least 8 seconds the 2 numeric button.
• Three final flashes indicate that the operation has been completed successfully.
• Now check if the remote control act properly.
If not, again repeat the procedure using the 3 numeric button.
To restore the remote control and return to the initial condition, perform the procedure using the 1 button.
To consult the key correspondence table between the Meliconi remote control and the functions of the original remote
control, go to www.cme.it
Keep this booklet for future reference
factory with a specific code.
to the chapter ACTIVATION OF REMOTE CONTROL.

SAFETY WARNINGS

INSERTING THE BATTERIES

GUIDE

ACTIVATION OF REMOTE CONTROL

, select the remote control model and click on "KEY CORRESPONDENCE TABLE".
EASY 300
SONY
digital television sets.
button and check that the LED blinks