LENCO MES-210 Instruction Manual page 29

System Setup
3. RESUME
This item is used to set last memory state.
Press the or button to highlight this item.
Press the button to enter the setup of this item.
Press the or button to choose on or off.
Press the ENTER/ENT button to confirm your
selection.
Press the button to exit from this item.
4. DEFAULTS
This item is used to reset the unit.
Press the or button to highlight this item.
Press the button to enter this item.
Press the ENTER/ENT button to reset.
Then all the settings of your unit are back to the
original state.
29