Advertisement
To search for a particular passage during playback( track scanning at high speed)
Press and hold SKIP BACKWARD/FORWARD button to scan the current playing track at high speed until
desired point(passage), then release the button.
Playback will start again from this point.
PROGRAM TRACKS
Program tracks of disc are possible when playback is stopped. Up to 20 tracks can be stored in the memory in
any order.
1. In stop mode, press PROG button to enter program setting, the
2. Press FORWARD SKIP button to select the first desired track to be programmed.
3. Press PROG button to enter. The display shows
4. Repeat steps 2 & 3 to store other desired tracks until all tracks programmed.
5. Press PLAY/PAUSE button to start playback from the first programmed track. The display will show
6. Press STOP button to stop program playback.
To Erase the Memory(Program)
To clear the program, you may have two ways:
1. Press STOP button when the disc stopped, or
2. Open the CD compartment lid, program will be erased.
REPEAT
You can play one track or all tracks on the disc repeatedly.
To Repeat a Single Track
1. Press REPEAT button once in play, "RPT" shows flashing in the display. The current track will be played
over and over again till you press STOP button.
2. To cancel repeat play, press REPEAT button twice. "RPT" goes off from display.
To repeat all the Tracks
1. Press REPEAT button twice in play, "RPT" shows steady in the display, all tracks on the disc will be played
over and over again till you press STOP button.
2. To cancel repeat play, press REPEAT button once. "RPT" goes off from display.
Note: Repeat function also can be done in stop mode.
SPEAKER CONNECTION
Connect each speaker to the corresponding speaker terminals on the back panel of the main unit. Make sure
that the left speaker is connected to the left pair of speaker terminals and the right speaker to the right pair of
speaker terminals. Also make sure that the speaker wires are correctly connected: that the red wires are
connected to the red terminals and the black wires to the black terminals.
GENERAL INFORMATION
MAINTENANCE
Types of Cassette
Use only good quality cassettes (IEC TYPE 1) for making recordings. May be used to replay other types of
cassette but is unable to make proper recordings on these more specialized tapes.
The use of C120 cassettes is NOT recommended in this machine.
Protecting Recording
Normally, anything recorded on the tape is automatically erased when new recording is made. It is possible
to protect your recording from accidental erasure by removing the tabs found on the rear of the cassette.
When the cassette is held with the recorded side uppermost and exposed tape facing the front, the
protective tab will be found on the left rear of the cassette.
All prerecorded cassette are protected in this way to prevent accidental erasure of the commercial recording.
"Protected" cassette will prevent the record button from being operated.
flashes on and off in the display.
flashing.
6
Advertisement
