Table of Contents
Advertisement
REMOTE CONTROL OPERATION
To operate the unit with the rem ote control, point the rem ote handset at the rem ote sensor on
the front panel and press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 m eters from the front panel and on an angle of
30 degrees. Bright sunlight or room light conditions can interfere with the rem ote control. If
the rem ote operation is unsatisfactory or stops working entirely, first try replacing the rem ote
batteries, then try reducing the room lighting conditions.
SPEAKER CONNECTION
Connect each speaker to the corresponding speaker term inals
on the back panel of the m ain unit. Make sure that the left
speaker is connected to the left pair of speaker term inals and
the right speaker to the right pair of speaker term inals. Also
m ake sure that the speaker wires are correctly connected: that
the red wires are connected to the red term inals and the black
wires to the black terminals.
GENERAL INFORMATION
MAINTENANCE
Types of Cassette
Use only good quality cassettes (IEC TYPE 1) for m aking recordings. May be used to replay
other types of cassette but is unable to m ake proper recordings on these more specialized
tapes.
The use of C120 cassettes is NOT recommended in this machine.
Protecting Recording
Norm ally, anything recorded on the tape is autom atically erased when new recording is
m ade. It is possible to protect your recording from accidental erasure by removing the tabs
found on the rear of the cassette.
When the cassette is held with the recorded side upperm ost and exposed tape facing the
front, the protective tab will be found on the left rear of the cassette.
All prerecorded cassette are protected in this way to prevent accidental erasure of the
com m ercial recording. "Protected" cassette will prevent the record button from being
operated.
Cleaning discs
When a disc becomes dirty, clean it with a cleaning cloth, wipe the disc from the center out.
Do not wipe in circular m otion.
Do not use solvents such as benzene, thinner com mercially available cleaners, or antistatic
spray intended for analogue records.
Cleaning the disc lens
After prolonged use, dirt or dust m ay accum ulate at the disc lens. To ensure good playback
E-9
Advertisement
Table of Contents
