Timer; Timer Playback And Timer Recording - Aiwa LCX-357 Operating Instructions Manual

TIMER

TIMER PLAYBACK AND TIMER
RECORDING
TIMER/
SLEEP
CD
POWER
a
f,g
The unit can be turned on at a specified time with the built-in
timer.
Preparation
Make sure the clock is correctly set. (See page 6.)
1 Press TIMER/SLEEP repeatedly to select timer
playback or timer recording.
"TM PLAY" for timer playback
"TM REC" for timer recording
2 Within 4 seconds, press a.
NOTE
If you do not press a within 4 seconds, another operation
may start.
3 Set the timer-on time.
Designate the hour of the timer-on time by pressing f or
g, and press a. Then designate the minute of the timer-
on time by pressing f or g, and press a.
16
ENGLISH
4 Press f or g to select the source, and press
a.
• For timer play of a CD, select "CD."
• For timer play of a tape, select "TAPE."
• For timer play/recording of a radio broadcast, select "FM"
or "AM." You will select the band later in step 6.
• For timer play/recording of the equipment connected to
the AUX jacks, select "AUX."
5 Select the duration for the timer-activated period
with f or g, and press a.
POWER
a
The duration for the timer-activated period can be set between
5 to 240 minutes in 5-minute steps.
f,g
6 Prepare the source.
• For timer play of a CD, load the CD.
• For timer play of a tape, insert the tape.
• For timer play/recording of a radio broadcast, press
TUNER/BAND to select the band and tune in to the desired
station.
• For timer play/recording of the equipment connected to
the AUX jacks, set the timer of the equipment so that play
begins at the same time.
7 For timer recording: Insert the tape to be
recorded.
8 Adjust the volume and tone.
The source sound will be audible at the volume set here when
the power turns on at the set time.
However, If the volume level is set to higher than 20, it is
automatically set to 20 when the unit turns on by the timer.
9 Press POWER to turn the unit off.
5 (and 4) remain on the display after the power is turned
off (timer standby mode).
When the timer-on time is reached, the unit turns on and
begins play (or recording) with the selected source.