Connections - Aiwa LCX-350 Operating Instructions Manual

CONNECTIONS
2
This system may be powered by an AC voltage or car battery
(.3C 12 V) power source. (Aiwa DCW-50 car battery cord is
available as an optional accessory, For details, please refer to
page 17.)
Elefcwe connecting the AC cord
The rated voltage of your unit shown on the rear panel is
120 V AC. Check that the rated voltage matches your local
voltage.
IMPORTANT
Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord or car battery cord in the end,
There are no differences between the front speakers. Both
speakers can be connected as L (Left) or R (Right).
3
Connect the supplied antennas.
Connect the FM antenna to the FM 75 Q terminals and the
AM antenna to the AM LOOP terminals.
AM LOOP antenna
Connect the AC cord to an AC outlet.
m
1' Connect the speaker cords to the main unit.
Do not short-circuit the ~ and ~ speaker cord leads, otherwise
The cords with the white stripes should be connected to the
the sound may become inaudible or the unit may be turned off.
~ terminals and the other cords to the O terminals.
If this happens, disconnect the AC cord from the AC outlet and
re-connect the speaker cord correctly. Connect then the AC cord
and turn the unit on again.
r
d
@
2
FM antenna
11(
-3
:3
ENGLISH