Pandora Moto Evo Wiring Diagram

WARNING!
information in Pandora Specialist app
and on specialist.alarmtrade.ru; update
installation; choose the vehicle model
code if the CAN-bus connected.
BASE UNIT
PLACEMENT
WARNING!
Keep minimum distance of 20 mm between
the system and metal parts.
Fixate the protective cap using
WARNING!
LED VALET microUSB
WARNING! The backup battery is charged
automatically when the engine is running.
The system uses the backup battery only
Li-Po accu
XP1
in security mode.
3.7V 330mAh
XP2
GSM/LTE (4G/3G/2G)
Antenna GNSS
(GPS/GLONASS)
WARNING!
Disarm the system
and disconnect
the power supply
before installing/
replacing
nano-SIM
a SIM-card.
Before installation: check the The installation locations of the
WARNING!
base unit and system elements must meet
their temperature, dust- and moisture-
protection characteristics. The base unit
is designed to operate at temperatures from
-40°C to +60°C, the degree of protection
is IP54.
Do not shield the built-in antennas.
16
15
14
13
12
11
10
9
8 16
8
7 15
7
6 14
6
5 13
5
4 12
4
3 11
3
2 10
2
1 9
1
WARNING! The system is a maintenance-
free device. In case of failure you must
immediately contact your local supplier.
Black
Orange/White
Orange/Black
Engine temperature sensor*
White
Blue/Black
External VALET button*
Red/Black
(+)
INP1 – "Ignition" input
Yellow
(+)
INP3 – "Brake" input
Blue/White
Red POWER SUPPLY (+12V)
500 mA (+12V)
CH7 – "Turn lights" output
Pink
500 mA (+12V)
Pink
CH6 – "Turn lights" output
500 mA (+12V)
Purple CH5 – "Siren/Beeper" output
200 mA (—)
INP2/CH4 – "Blocking 1 NC" output
Green
200 mA (—)
Blue CH3/INP6 – "Trunk" input
200 mA (—)
Brown/White CH2/INP5 – "Trunk" input
200 mA (—)
CH1/INP4 – "Clutch" input
Grey
Pandora Moto Evo
WIRING DIAGRAM
WARNING! All power circuits of additional IT IS FORBIDDEN
devices that are not powered through the system on a vehicle with normal
base unit of the system should have their voltage other than 12V.
own fuses. IT IS FORBIDDEN
bypass original fuses of a system
in the installation process.
IT IS FORBIDDEN
system with damaged output
cables.
IT IS FORBIDDEN
CAN-H
temperature sensor at the place
where temperature is higher than
the operating range of the sensor
CAN-L
(+125°C) and cable (+80°C).
IP40
86
87a
30
85
+12V
clutch trigger
to install the
to change or
to install the
to install the
*Cut the connector
when connecting
external tempera-
ture sensor
or VALET button
IP65
IP54
Green/Black
NC
Green/Red COM
NО
Green
to original wiring
v 1.0