Page 2
However, traditionally, increasing the number of blades on a propeller decreases effi ciency as each additional blade disturbs the water flow and force of the next blade and increases friction. To counter this Sleipner Q-PROP™ blades are uniquely skewed to gradually slice through water over the blade edge rather than striking the water simultaneously with a common straight edge blade.
Page 3
KIT #4 9999 (SP55) and #7 9999 (SP75/ SP95) MC_0446 Parts: 1: Screw for zinc anode 2: Zinc anode 3: Propeller locknut 4: Washer 5: Q-PROP™ 6: Adapter 7: Propeller drive pin Removing old propeller(s) Loosen and remove screw for zinc anode (1), zinc anode (2), locknut (3) and washer (4) Remove the old 4-blade propeller from shaft.
Page 5
Maintenance MC_0446 For Thruster maintenance please refer to your supplied user manual User Manual Thruster User Manual SLEIPNER AS DOCUMENT ID: P.O. Box 519 REVISION: DATE: N-1612 Fredrikstad Norway LANGUAGE: www.sleipnergroup.com To download your language go to www.sleipnergroup.com Sleipner Guide...
Need help?
Do you have a question about the 4 9999 and is the answer not in the manual?
Questions and answers