Table of Contents
Advertisement
4. Insert the CD-ROM labeled "Raptor Drivers for HP-UX" into the
drive.
5. Run swinstall. Accept all the path defaults.
6. The swinstall program will automatically try to locate,
mount, and read any CD-ROM device present. If the program
is
successful,
TSIFTHPUX_11. If this is not displayed, please proceed to the
section titled, "Mounting the CD-ROM Manually." See Section
3.2.4.
7. Move the cursor down to the TSIFTHPUX_11 package and
highlight it by pressing <space>.
8. Press <tab> to activate the menu bar. Move the cursor across
to 'Actions' and press <Enter>. Move the cursor down to
'Install (analysis)' and press <Enter>.
9. Follow the on-screen instructions to complete installation. If
any warnings or errors are reported, check the Logfile (default:
/var/adm/sw/swagent.log), correct the errors, then
continue.
3.2.3 Installation on HP-UX 11i
The following are step-by-step instructions for installing the Raptor
Drivers for HP-UX 11i software from a CD-ROM.
1. Install a supported Raptor card in the HP workstation/server,
and boot the system.
2. Log in as root on the target system, using /sbin/sh as your
shell.
3. Uninstall any previous version of Raptor software in accordance
with the instructions supplied with that software.
Chapter 3 - Software Installation
it
will
display
TSIRDHPUX_11
3-3
and
Advertisement
Table of Contents
Need help?
Do you have a question about the RAPTOR DL-LITE - DRIVERS FOR HP-UX INSTALLATION-REFERENCE and is the answer not in the manual?