Hardware Installation; Hardware Configurations Supported; Installation Instructions - Tech Source RAPTOR DL-LITE - DRIVERS FOR HP-UX INSTALLATION-REFERENCE Installation And Reference Manual

HARDWARE INSTALLATION

2.1 Hardware Configurations Supported

The Raptor DL-Lite graphics cards have been tested on and
currently support the following PCI based HP workstations/servers:
•
HP B-class
•
HP C-class
•
HP J-class

2.2 Installation Instructions

Installing a Raptor card is simple and consists of a few easy steps.
NOTE: Remember which cables go to which connectors. You
may want to label the cables and connectors before
disconnecting them.
Step 1: Shut down the system and turn the power OFF. Remove
the system's cover along with any cables that prevent you
from doing so. Find an available PCI slot, and remove the
bracket and screw. Ground yourself by touching the metal
part of the case.
Step 2: Install the Raptor card firmly into the PCI slot. Take care to
press it evenly and snugly into the slot. Once you are
certain the card is installed properly in the slot, secure it
with the bracket screw.
Step 3: Secure the system's cover and reattach any previously
removed cables.
Step 4: Connect the Dual Link DVI cable from the Apple HD panel
Chapter 2
2-1