Maple Systems cMT Series Quick Start Manual page 5

cMT Series Quick Start Guide
cMT-SVR Models
The cMT-SVR models are human-machine interfaces (HMI) without built-in display. cMT-SVR devices are
configured with EasyBuilder Pro and store the screens and related logic in a small DIN rail mountable
form factor. The programmed screens can be viewed externally over the LAN with the cMT Viewer
application. This can be done using an Ethernet connection to a PC or cMT-iV5 display, or via a Wi-Fi
connection to a smart phone or tablet.
cMT-SVR Models:

cMT-SVR-100: The base cMT-SVR unit, offers the core cMT functionality

cMT-SVR-102: This option is pre-activated for remote access with EasyAccess2.0

cMT-SVR-OPCUA: This option comes licensed to be used as an OPC UA server

cMT-HDMI: This option has an HDMI out port to allow screens to be displayed on a connected
monitor
cMT3000 Models
The cMT3000 models add a built-in touchscreen display to the cMT-SVR features. They are designed to
be panel mounted and allow for two additional client display devices running cMT Viewer to connect via
Ethernet or Wi-Fi to control your system. They add support for CANbus and are pre-licensed for use as
OPC UA servers.
cMT3000 Models:

cMT3072: 7" touchscreen with built-in cMT-SVR functionality

cMT3090: 9.7" cMT server device, built-in mono speaker

cMT3103: 10.1" cMT server device with built-in Wi-Fi connectivity

cMT3151: 15" cMT server device, analog video inputs
The cMT-iV5 Display
The cMT-iV5 is a 9.7" touchscreen display designed specifically for use with cMT server products (cMT-
SVR and cMT3000 models) and cannot be used on its own. It has the same look and feel as an iPad or
Android device with a capacitive touchscreen that supports swipe, pinch, and zoom functionality, but is
designed to be hardwired into a panel. The cMT-iV5 is used as a local touchscreen with an Ethernet
cable connected to the local network switch, or directly to the cMT server device.
The cMT-iV5 Stand
The packing box for the cMT-iV5 (as well as the cMT3090) can be transformed into a stand for mounting
the display. Follow these steps to assemble the stand.
1. Remove the center of the box cover along the perforated line.
2. Pull the two inner flaps toward the sides as shown in the illustration below.
3. Press down along the perforated line inside the box.
4. Complete the stand as shown.
cMT Series Quick Start Guide
5
5